Service Call Procedures; Punch Quality; Parts List; General Procedures - GBC MFPP-C1 Service Manual

Organization

This documentation is divided into eight sections. In addition to the
Introduction, this documentation contains the following sections.
Section 1

Service Call Procedures

Section 2 Repairs and Troubleshooting Procedures
Section 3

Punch Quality

Section 4 Adjustments and Replacement Procedures
Section 5

Parts List

Section 6

General Procedures

Section 7

Wiring Data

Section 8 Installation Checklist

How to Use This Documentation

Introduction

This section provides the Service Representative with information
pertaining to the organization and use of this service documentation.
Section 1: Service Call Procedures
This section is used by the Service Representative as a structured
process for determining the type and sequence of actions that are
performed during a service call. The Service Call Procedures section is
designed to assist in the effective recognition of machine symptoms and
problems, as well as to provide instructions for the maintenance and
corrective actions that are required to return the machine to the full
operating condition
Service Manual
Section 1 of this service documentation is the entry level for all service
calls. The Service Representative should begin each service call with the
Initial Action Procedure found in Section 1.
The Service Call Procedures section is composed of five integral
elements: Initial Action, System Checks, Every Call Activities, Scheduled
Maintenance, and Final Action.
The maintenance and diagnostic activities in this section may direct the
Service Representative to perform additional service activities found
elsewhere in the documentation, such as RTPs, Replacement
Procedures, and Adjustment Procedures.
Section 2: Repairs and Troubleshooting Procedures
(RTP)
Section 2 of this documentation contains the Repair and Troubleshooting
Procedures (RTPs) necessary to repair all faults associated with MFPP-
C1. Service Representative will be referred to this section from some
other section of this documentation during the service call. When a
machine defect or fault has been resolved by using a RTP, the Service
Representative should immediately return to the point in the service call
from which Section 2 was entered. There are two types of RTPs found in
Section 2. The first type is a RTP that is associated with the display of an
error message in the RTP title. The second type is the Troubleshooting
RTP. Troubleshooting RTPs are diagnostic procedures that are designed
to address symptoms or problems that are not identified by, or
associated with, a displayed status or fault code.
Section 3: Punch Quality
This section is used to diagnose punch quality defect problems.
Section 4: Adjustments and Repair Procedures (ARP)
This section contains all repair and adjustment procedures for the
machine. Repairs (ARPs) and adjustments (ADJs) are identified by the
use of a standard chain prefix number.
Section 5: Parts List
This section contains a list of spare parts for the machine. All parts list
page reference numbers begin with the letters "PL", followed by a prefix
number, a decimal point, and a sequential number used within the
subsystem.
06/22/2022
iv
MFPP-C1