Troubleshooting - D-Link DWL-810 Owner's Manual

3. Turn on the power of the DWL-810 by connecting one end of the
power adapter (included with your purchase) into the power port on
the DWL-810, and connecting the other end into the AC power outlet
on your wall.
4. The DWL-810 will automatically detect the MAC address of the
network device to which it is connected, and begin wireless
transmission to other wireless-enabled devices.
7.

Troubleshooting

This section provides solutions to situations that can occur during the
installation and operation of the DWL-810 Ethernet-to-Wireless Bridge.
Read the following descriptions if you are having problems.
1. The DWL-810 Ethernet-to-Wireless Bridge Power light is not on.
•
Check to see if the DWL-810 Ethernet-to-Wireless Bridge power
adapter is connected properly to a known good power outlet.
2. The DWL-810 Ethernet-to-Wireless Bridge Link light is not on.
•
Make sure that the Ethernet cable is connected properly and your
Ethernet adapter supports 10BaseT.
Advanced Setup (optional)
For advanced setup features, enter
Internet browser and gain access to the web configuration of the
DWL-810. The advanced setup features can be used to change the
LAN and wireless settings for your DWL-810 Ethernet-to-Wireless
Bridge.
3. I cannot connect to another wireless client.
•
The DWL-810 Ethernet-to-Wireless Bridge has a default SSID of
default. Make sure that the SSID on the DWL-810 Ethernet-to-
Wireless Bridge is exactly the same as the SSID on the other
wireless client.
http://192.168.0.30
20
into your