- Do not touch the heating element during or after a wash cycle. subsequent modifications. - Do not lean or sit on the door when it is open ,as this could - Carefully dispose of the packing material. overturn the dishwasher.
Close-up View (Interior) Washing Filter Upper Rack Top Spray Arm Detergent and Rinse Aid Dispenser Lower Rack Salt Container Cap Bottom Spray Arm Technical characteristics Width 60 cm Depth 58 cm Height 82 cm 12 standard place settings Capacity Mains water pressure 0.03-0.6MPa...
- Carefully screw the cap back on. - Unscrew the cap from the salt container; - There is a ring on the container with an arrow on it (see figure to the side); - If necessary, rotate the ring in an anti-clockwise direction from the "-"...
To open the dispenser, turn the "C" cap in an anti-clockwise compartment. direction and then pour in the rinse aid, making sure not to overfill. After the detergent has been placed in the dispenser, close the The amount of rinse aid used for each cycle can be regulated by cover and press down until it clicks in place.
It is preferable to place serving dishes and lids on the sides of Load for 12 Standard Settings (for EN 50242 tests) the racks in order to avoid blocking the rotation of the top spray arm.
Setting and Starting a wash Cycle Choose the desired cycle by pressing the cycle selection button "C". Each time it is pressed, one of the cycle indicator lights "D" At the end of the wash cycle... will come on in succession.
Hot rinse. Run immediately after Drying. dishes are used. Glassware Economic, fast cycle to be used to on not very Short wash at 40 . dirty dishes right after Cold rinse. they are used. No dry- ing cycle. Rapid Wash...
Moving the Appliance plug from the socket. Do not run risks. If the appliance must be moved, try to keep it in a vertical position. No solvents or Abrasive Cleaning Products If absolutely necessary, it can be positioned on its back.
Cycle while Underway". Then check to make sure that there The Dishwasher Does Not Start is water in the mains and that the tap is turned on. If the message Have you checked whether: continues, call for technical assistance, indicating which message - the plug is pushed into the socket correctly;...
If the water pipes are new or have not been used for an extended period of time, let the water run to make sure that the water is clear and free of impurities. If this precaution is not taken, there is a risk that the water inlet can get blocked and damage the appliance.