General Introduction The BY-WM3T is an ultra-compact and portable 2.4GHz wireless microphone system. It is ideal for content creation, live streaming, vlogging, mobile journalism and much more. This series has 3 di erent receiver options: 3.5mm TRS, iOS Lightning or USB-C output included in the kits, compatible with a camera, smartphone, tablet, computer and more.
4. Please clean the device with only a soft, dry cloth. 5. When using and storing, please keep away from dust and moisture. 6. For the best pick-up pattern, do not hold your hand against the microphone capsule cover. Product Structure BY-WM3T-TX: Wireless Transmitter...
Page 4
1. Built-in microphone 2. Status indicator Status Indicator Unpaired Blinking red and blue alternately Paired successfully Static blue Mute Blinking blue slowly Noise cancellation enabled Static green Low battery Blinking red slowly Charging Static red (in shutdown mode) Fully charged Red light o Note: If charging the unit when it is ON, the indicator will display the current working status instead of charging status.
Page 5
BY-WM3T-RX35:3.5mm TRS Receiver 1. Status indicator Status Indicator Unpaired Blinking red and blue alternately Paired successfully Static blue Low battery Blinking red slowly Charging Static red (in shutdown mode) Fully charged Red light o Note: If charging the unit when it is ON, the indicator will display the current working status instead of charging status.
Page 6
It can be connected to an iOS USB-C devices. Lightning device. 3. USB-C charging port 3. USB-C charging port When the BY-WM3T-RXU is When the BY-WM3T-RXD is plugged into an external device, plugged into an external device, the external device can be the external device can be powered via this charging port.
Page 7
BY-WM3T-CC: Charging Case 1. Slot for transmitter(s) 2. Slot for receiver 3. Charging indicator Status Battery Level Indicator Low battery <10% Charging ≤25% 26≤50% 51≤75% 76≤99% Fully charged 100% 4. USB-C charging port...
2 seconds to power on). 2. The transmitter(s) and receiver will be automatically paired. Their indicators are all static blue. 3. Plug the BY-WM3T-RX35 receiver into a device with a 3.5mm TRS jack. 4. You are ready to record.
Troubleshooting If you encounter problems when using the unit, please refer to the following checklist before contacting technical support. If the problem cannot be solved, please contact the dealer's after-sales service department. • If there is no sound from the unit or no sound when connected to an external device ➀...
Specifications Transmitter & Receiver 2.4GHz digital frequency Transmission Type GFSK Modulation Omnidirectional Polar Pattern Ceramic antenna Antenna Up to 100m (without obstacle) Operating Range RF Output Power <10dBm Distortion ≤0.1% 20Hz-20kHz Frequency Response -40dB±2 (1V/Pa) Sensitivity Sampling Rate 48kHz Bit Rate 16bit Signal-to-Noise Ratio 85dB...
Page 21
SHENZHEN JIAYZ PHOTO INDUSTRIAL., LTD. The BOYA logo is a trademark which is registered and owned by Shenzhen Jiayz Photo Industrial., Ltd. 深圳市长丰影像器材有限公司 地址:广东省深圳市龙华区观澜街道大富社区硅谷动力智能终端产业园A��栋 TEL: 400 6131096 Email: sales@boya-mic.com www.boya-mic.com / www.jiayz.com...
Need help?
Do you have a question about the BY-WM3T and is the answer not in the manual?
Questions and answers