Ultracompact 2.4ghz dual-channel wireless microphone system (26 pages)
Summary of Contents for Boya BY-V Series
Page 1
2.4 GHz Wireless Microphone System 2.4 GHz无线麦克风系统 BY-V User Manual 用户手册...
Page 2
Please save the manual for future reference. If you need further assistance than the user manual, please consult your retailer for help or email us at: sales@boya-mic.com Cautions 1. Non-professional teardown is strictly prohibited.
General Introduction BY-V, a lightweight and easy-to-use 2.4 G wireless microphone system, renders ease of operation and remarkable exibility for high-quality recording. The microphone system supports connecting a receiver with 2 transmitters for 2-person recording, ideal for content creation, live streaming, vlogging, mobile journalism, and more.
Product Structure BY-V-TX Transmitter ❶ Built-in Microphone ❷ Indicator Status Indicator Unpaired Blinking blue and red alternately Paired successfully Static blue Microphone Muted Blinking blue slowly Noise reduction enabled Static green Low battery Blinking red Charging (in shutdown mode) Static red...
Page 5
Note: • Please charge the transmitter when the indicator indicates low battery status, or it will automatically shut off within 10 minutes. ❸ NR Button Press to enable or disable the noise reduction. • The noise reduction feature cannot be enabled or disabled when the microphone is muted.
Page 6
BY-V-RXU Receiver ❶ USB-C Connector It can be connected to a device featuring a USB-C port. ❷USB-C Port It can be connected to a charging cable to charge your smartphone when the receiver is connected to the phone. ❸Indicator Status Indicator Unpaired Blinks blue...
Page 7
BY-V-CC Charging Case ❶ Slot for Transmitters ❷ Slot for Receiver ❸ Charging Contacts For charging transmitters. ❹Indicators • When the charging case is connected to power, these indicators display as follows: Battery level (case) Indicator 25% or lower 26% - 50% 51%~75% 76%~99% 100%...
• When the charging case is not connected to power and the transmitter(s) is placed into it, these four indicators will display the case’s current battery level. Four indicators can show the case’s battery level with 4 scales, 25%, 50%, 75%, 100%. Each indicator represents 25%. ❺USB-C Charging Port For charging the case.
5. Some phones may default to using its built-in microphone, so you need to switch to the external microphone (BY-V). 6. You are ready to record. Tips: 1. It is recommended to record a sample and play it back to check if the audio level is acceptable before recording.
Page 10
The operation range of the unit is limited and the sound is frequently intermittent Make sure there is no interference between the transmitter(s) and receiver. If the intermittent sound still occurs frequently, please contact our customer service. The unit shuts off automatically When not paired, the transmitter(s) will automatically shut down after 10 minutes.
Specifications BY-V-TX Transmitter Transmission Type 2.4 GHz Modulation GFSK Polar Pattern Omnidirectional Antenna PCB antenna Frequency Range 2402-2480MHz Operating Range 100 m (without obstacles) Distortion ≤0.1% Frequency Response 20 Hz - 16 kHz Sensitivity -42 dB Sampling Rate 48 kHz Signal-to-Noise Ratio 80 dB Audio Input Built-in capsule...
Page 12
BY-V-RXU Receiver Transmission Type 2.4 GHz Modulation GFSK Polar Pattern Omnidirectional Antenna PCB antenna Frequency Range 2402-2480MHz Operating Range 100 m (without obstacles) Signal-to-Noise Ratio 80 dB Distortion ≤ 0.1% Frequency Response 20 Hz - 16 kHz Power Supply Powered by an external device Audio Output USB-C Weight...
BY-V-CC Charging Case Battery Type Built-in Li-ion battery Battery Capacity 3.7 V / 400 mAh Charging Time Approx. 2 hours Power Supply USB-C (DC 5 V / 1 A) Charge Cycle Times Approx. once (2*TX) Weight Approx. 86.5 g Dimensions 62 ×...
Page 15
FCC Warning This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
Need help?
Do you have a question about the BY-V Series and is the answer not in the manual?
Questions and answers