Advertisement
Quick Links
Advertisement
Related Manuals for Lambda SWS600L
Summary of Contents for Lambda SWS600L
- Page 1 SWS600L Compact and high-power AC/DC power supply...
- Page 2 SWS600L SWS600L The new generation 600 Watt AC/DC power supplies has now been added to Lambda’s Compact and high-power AC/DC power supply reliable and field-proven SWS family. The Best Power Solution for Model name identification method Display Technologies SWS 600 L–5□...
-
Page 3: Outline Drawing
Outline Drawing SWS600L Specifications MODEL SWS600L-5 SWS600L-12 SWS600L-24 ITEMS/UNITS Voltage Range (*3) AC85 ~ 265 or DC120 ~ 350 Frequency (*3) 47 - 63 Power Factor (typ) (115/230VAC) (*2) 0.98 / 0.95 Input Efficiency (typ) (115/230VAC) (*2) 75 / 77... - Page 4 Block Diagram SWS600L Instruction Manual BEFORE USING THE POWER SUPPLY UNIT Be sure to read the following precautions thoroughly before CAUTION using this power supply unit. Pay attention to all warnings and cautions before using the unit. Incorrect usage could lead to an electrical shock, damage or a ●...
- Page 5 10%(2V output model: Load ̲ 101% of peak current) of maximum DC output current speci- SWS600L Panel Side fication. The output will be automatically recovered when the • Basic connection (Local sensing) • Remote sensing required overload condition is cancelled.
- Page 6 3) Remote ON/OFF control circuit is isolated from the input load terminal. The output ripple cannot be measured accurately Maximum of total output current in parallel operation ≤ Rated Output〜FG(chassis):500VDC 50MΩor more Output〜CNT･AUX･ALM :100VDC 50MΩ or more and output by a photo-coupler and can be controlled regard- if the probe ground lead of oscilloscope is too long.
-
Page 7: Mounting Directions
AWG #2 0.2 〜 0. connector made from JAPAN SOLDERLESS TERMINAL Note1. Crimp height at wire barrel should be set to pre-determined SWS600L 1 Mounting Directions. dimensions. MFG CO LTD. Regarding to manufacture of a connector, it Note2. Adjust crimp height at wire insulation barrel to the extent becomes the regulation as following. - Page 8 7. Fan life expectancy The Fan-life has limitation. Therefore, periodic maintenance Fan acoustic noise: dB[A] typical, 0dB[A] maximum by exchanging the life-expired fan is required for the power sup- d). Mating and Unmating Connector ply. The following figure shows the life of fan (1) Inserting connector Hold receptacle housing securely and insert into header Fig.2: Examples of defective crimping...
- Page 9 TDK Corporation or DENSEI-LAMBDA K.K. or any of its affiliates in Japan and other countries. Not all trademarks or registered trademarks stated herein are followed by (R) or (TM).
Need help?
Do you have a question about the SWS600L and is the answer not in the manual?
Questions and answers