Aiwa NSX-V70 Operating Instructions Manual page 54

SETTING THE TIMER
To cancel timer standby mode temporarily
Press the TIMER button on the remote control so that @ or
R~C
disappears on the display.
~ restore the timer standby mode, press again to display 0 or
REC
Using the unit while the timer is set
You can use the unit normally after setting the timer.
Before turning off the power, repeat step 5 to prepare the source,
and adjust the volume and tone.
Timer playback and timer recording will not begin unless the
power is turned off.
Connected equipment cannot be turned on and off by the built-
in timer of this unit. Use an external timer.
TIMER RECORDING
Timer recording is applicable for TUNER and VI DEO/AUX (with
an external timer) sources only.
Press the TIMER button twice on the remote control so that
~Cappears on the display, and press the II SET button within
4 seconds. Repeat the steps in page 52 from step 2 and insert
the tape to be recorded into deck 2 after step 5.
SETTING THE SLEEP TIMER
The unit can be turned off automatically after a specified time
passes.
Use the remote control.
1
Press the SLEEP button.
"SLEEP" @ lights up, and SLEEP @ is displayed for 4
seconds.
2 Within 4 seconds, press the * or FP button to
specify the time until the power is turned off.
Each time the button is pressed, the time changes between
10 and 240 minutes in 10-minute steps. The specified time
@is displayed.
To check the time remaining until the power is turned off
Press the SLEEP button once. The remaining time is displayed
for 4 seconds.
To cancel the sleep timer
Press the SLEEP button twice so that "SLEEP on the display
disappears.