Yamaha M7CL Supplementary Manual page 5

Channel link level differences maintained,
and can temporarily defeated
When you enable channel link, HA gain and fader opera-
tions will now be linked while maintaining the level dif-
ference between channels of the link group.
● Temporarily defeating link
For parameters (HA gain and fader) that preserve their rel-
ative level differences when linked, you can temporarily
defeat linking for all linked channels, for example when
you need to adjust the level balance between channels of a
link group. Hold down the [SEL] key of the channel
whose balance you want to adjust, and operate the param-
eter that you want to modify. While you're holding down
the [SEL] key, the HA gain and fader will not be linked.
(However, temporary unlinking is not possible during the
fade that occurs when a scene memory is recalled.)
Using the STEREO/MONO MASTER fader to
adjust the monitor output level
A monitor fader has been added to the monitor output
level control, allowing you to use the STEREO MASTER
fader / MONO MASTER fader to control the level.
You can now also use the [ON] key of the MONO channel
and STEREO channel to turn the monitor output on/off.
A new MONITOR FADER field has been added in the
MONITOR screen and the MONITOR popup window.
[MONITOR screen]
1
[MONITOR popup window]
1
1
MONITOR FADER LEVEL
Indicates the current monitor fader.
B
FADER ASSIGN MODE button
Each time you press this button of the MONITOR popup
window, you will alternate between NONE → STEREO →
MONO → NONE.
If you select STEREO, you'll be able to use the top panel
STEREO MASTER fader to control the monitor fader. You
can also use the [ON] key located above the STEREO MAS-
TER fader to turn the monitor output on/off.
If you select MONO, you'll be able to use the top panel
MONO MASTER fader to control the monitor fader. You can
also use the [ON] key located above the MONO MASTER
fader to turn the monitor output on/off.
NOTE
• The monitor fader and MONITOR LEVEL knob are located in
series. The top panel MONITOR LEVEL knob is still valid
even when you're using this function to adjust the monitor
level. The monitor signal will not be output if the MONITOR
LEVEL knob is set to the minimum position.
• The [ON] key of the STEREO channel or MONO channel will
operate in tandem with the MONITOR screen's OUTPUT but-
ton. The PHONES OUT jack will always output the monitor
signal, regardless of whether the OUTPUT button is on or off.
• You can also assign a user-definable key to switch the
FADER ASSIGN MODE setting (p. 7).
• The MONITOR button of the function access area is shown in
red for STEREO or in yellow for MONO, depending on the
FADER ASSIGN MODE setting.
5
2