Table of Contents Before You Start......... Classification of Safety Warning Messages..........Obligations of the User...... Product Overview ......Intended Use........For Your Safety ........Hazards and Safety Instructions..Selection of the Core Temperature .. Getting started........Establishing a Bluetooth® Connection ........Operation...........
Thermomix® TM6, which was supplied with the device. If you do not have the user manual to hand, all manuals are available online at https:// thermomix.vorwerk.com. Welcome Booklet Read our digital welcome booklet for more inspiration and tips on using Thermomix® Sensor.
NOTE Material damage if hazard is not avoided. 1.2 Obligations of the User To ensure that your appliance and Vorwerk accessory operate correctly, please follow the guidelines below: 1. Please read the instruction manual and all accompanying documents carefully.
Product Overview 1 Probe 3 Battery compartment (on reverse of the charger) 2 Charger 4 Holder Intended Use Use the device and accessories only for their intended purpose in order to minimise risks to you and other people and to minimise damage to the device or to other property and equipment.
Page 6
The device complies with the safety regulations of the country in which it has been sold by an authorised Vorwerk organisation. If the device is used in another country, compliance with the local safety standards cannot be guaranteed. Vorwerk therefore assumes no liability for any resulting safety risks for the user.
For Your Safety Safety is an essential part of every Vorwerk product. However, product safety can only be assured if the device is used correctly and all safety instructions are followed. 4.1 Hazards and Safety Instructions WARNING Explosion hazard If the rechargeable batteries built into the tip of the probe are not protected from high heat levels (>...
Page 8
Explosion hazard When the batteries built into the probe overheat, the probe could explode. • Use the probe at a maximum ambient temperature of 275°C. • Never put the probe onto a fire or hot coals. • Never expose the probe to direct flames. •...
Page 9
Fire hazard If incorrect batteries are used, mechanical overload (dropping the charger) can result in a fire. • Only use non-rechargeable alkaline batteries of type LR03, AAA, 1.5V cell (1.5V primary cell). • Handle the charger with care. Risk to health The consumption of insufficiently cooked food (especially meat, fish or seafood) can cause food poisoning.
Page 10
Risk of contact with dangerous substances Leaked electrolyte from batteries and rechargeable batteries can cause injuries. • Do not touch leaked electrolytes or electrolyte residues from leaking batteries or rechargeable batteries without skin or eye protection. • Leaking electrolytes must not come into contact with skin, eyes or mucous membranes.
Page 11
Risk of fire or explosion Charging non-rechargeable batteries can cause a fire or explosion. • Only use non-rechargeable alkaline batteries of type LR03, AAA, 1.5V cell (1.5V primary cell). NOTICE Risk of damage The charger can get damaged if handled incorrectly.
Risk of damage to the charger Moisture inside the charger can damage it. • Never pour water over the charger. • Do not hold the charger under running water. • Never immerse the charger in water or other liquids. • Only clean the charger with a slightly damp (not wet) cloth.
2. Allow the probe to charge for approx. 2 hours in the charger with the cover closed. 3. Download the app. 4. Remove the probe from the charger. ð The LED will flash green to indicate that the probe and charger are connected. 5.
Operation 7.1 Switching on and off When you take the probe out of the charger, it will automatically start up. To switch the probe off, put it back into the charger and close the cover. 7.2 Design of the probe 1.
Page 15
2. The temperature sensor (2), which measures the core temperature, is located 2cm behind the tip. Position this part of the probe as close to the centre of the food as possible. 3. The notch (3) will disappear into the food as you do so.
2. Depending on the preferred angle, select opening A or B and slide the probe through the holder and into the food. 3. Make sure that the tip of the probe (3) does not touch the baking tin. 7.4 Positioning the probe and charger During the cooking process, the probe continually measures the core temperature and ambient...
This instruction manual is available in other languages at https://vorwerk.com Warranty/Liability for Material Defects Thermomix® and its accessories may only be repaired by Vorwerk Customer Service or an authorised Vorwerk repair service. Thermomix® Sensor...
Only use original parts supplied with Thermomix® or original spare parts from Vorwerk Thermomix®. Never use Thermomix® in combination with parts or equipment not provided by Vorwerk Thermomix® for Thermomix®. Otherwise your warranty and the liability for material defects shall be rendered void.
The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. Any use of these word marks and logos by Vorwerk Elektrowerke GmbH & Co. KG is under licence. Declaration of conformity Vorwerk Elektrowerke GmbH & Co. KG hereby declares that the radio equipment type Thermomix®...
Need help?
Do you have a question about the thermomix TM6 and is the answer not in the manual?
Questions and answers