Epson Disc producer PP-100III User Manual page 152

Error associated with drive (only for PP-100III/PP-50II)
Lights
Stacker Conditions/Remedies
Power Busy Error Ink
1 2 3 4
Drive tray open/close error
Turn off the product, unplug the power cord,
and check inside for any objects. Then,
publish the disc again. If the same error
occurs frequently, contact your dealer.
Internal drive error
Turn off the product, unplug the power
cable, and then check the inside of the drive.
If the same error occurs frequently, contact
your dealer.
Writing/reading error
The error could not be cleared even if it
repeated itself for the retry number of times.
Disc may have a problem. Replace the disc
and resume job.
If there is a problem with the drive, change
the drive with EPSON Total Disc Setup and
resume the job. For the PP-100III, also check
if the drive has reached the end of its service
life. If so, replace the drive. See "Getting
Maintenance Information" on page 140 and
"Replacing the Drive (Only for PP-100III)" on
page 143.
If the same error occurs frequently, contact
your dealer.
Invalid disc error
An invalid disc error has occurred, such as
the disc may not be blank or the disc does
not have enough space. Or, the disc loaded
in the stacker differs from the disc type you
set in the EPSON Total Disc Setup Properties
dialog box.
The error could not be cleared even if it
repeated itself for the retry number of times.
Check that the disc is blank and not
damaged.
Then, in the EPSON Total Disc Setup
Properties dialog box, select the disc type
that is the same as the discs loaded in the
stacker. If you use the proper disc but the
same error occurs frequently, contact your
dealer.
Troubleshooting 152