Haier HDY6-1 User Manual page 18

English
4. Thread a U.L. approved 30 Amp power cord, NEMA 14-30 type ST or SRDT
through the strain relief.
5. Attached the green power cord ground wire to the cabinet with green
ground screw.
6. Attached the white (neutral) power cord conductor from the power cord and
the green ground wire from the dryer harness to the silver-colored center
terminal on the terminal block. Tighten the screw securely.
7. Attached the red and black power cord conductors to the outer brass-colored
terminals on the terminal block. WARNING: Do not make a sharp bend or
crimp wiring/conductor at connections.
8. Tighten the screws securing the cord restraint firmly against the power cord.
9. Tighten the strain relief nut securely so that the strain relief does not turn.
10. Reinstall the terminal block cover.
Caution: Label all wires prior to disconnection, when servicing
Warning: Discard or destroy the carton anbd plastic bags after the
Warning: The instructions in this manual and all other literature
17
controls. Wiring errors can cause improper operations
and be dangerous. Check unit for proper operation
after servicing.
dryer is unpacked. Children should not be allowed to use
them to play with. Cartons covered with rugs, bedspreads,
or plastic sheets can become an airtight chamber and cause
suffocation leading to death. Make all packing materials
inaccessible to children.
included with this dryer can not cover every possible
condition and situation that may occur. Good safe practice
and caution must be applied when installing, operating and
maintaining any appliances. After installing, if you
are in doubt, call a certified electrician to install and
wire the dryer.