Dsp Surround System - Aiwa NSX-AV800 Operating Instructions Manual

GRAPHIC EQUALIZER
DSP SURROUND SYSTEM
PA– —-- —- — — — — -*B
__–_;--
L-.
.—— —
---- -
J_ --- ----
.
GEQ
This unit provides the following three different equalization curves.
ROCK: Powerful sound emphasizing treble and bass
POP: More presence in the vocals and midrange
CLASSIC: Enriched sound with heavy bass and fine treble
Press the GEQ button repeatedly until the
equalization curve is displayed.
desired
bROCK+ POP+ CLASSIC+ EQOFFJ
I
(cancel)
SOUND ADJUSTMENT DURING
RECORDING
The output volume and tone (except BBE) of the speakers or
headphones may be freely varied without affecting the level of
the recording,
Recording with BBE
The desired source can be recorded with the BBE function to
enhance the clarity of high-frequency sound. When playing back
a tape recorded with BBE, it is recommended that BBE be set to
off
J.. _
1- ._ —. —--
_ — ——.—-
The DSP (Digital Signal Processor) surround circuits can recreate
the effect of sounds reflected from walls or ceilings, to obtain the
sound presence of real environments.
There are three modes with matching graphic equalization
curves.
Press the SURROUND button repeatedly
desired SURROUND mode is displayed.
%ISCO+LIV; +HALL+ S-OFFJ
(cancel)
Equalization curves are selected automatically to
until the
match the
SURROUND modes and can also be selected or turned off to
suit your preference.
When the music source is monaural
Select LIVE to obtain a simulated stereo effect. When DISCO or
HALL is selected, no sound will be heard from the surround
speakers.
To cancel the selected mode
Press the selected button again. S-OFF is displayed.
While SURROUND mode is off, no sound is heard from the
surround speakers.
To adjust the volume of the surround speakers
Press the MANUAL SELECT button once on the remote control.
"S is displayed for 2 seconds. Press the +< DOWN or UP
P button on the remote control within these 2 seconds.
The Dolby Pro Logic surround speakers level is also changed.
(See page 17.)
When a connected microphone is used, the SURROUND
system is automatically canceled.
When the DOLBY PRO LOGIC is turned on, the SURROUND
system is automatically canceled.
Using the headphones
Connect headphones to the PHONES jack with a stereo standard
plug (06.3 mm,
'/4
inch).
No sound is output from the speakers while the headphones are
plugged in.
When the headphones are plugged in, the SURROUND system
and the DOLBY PRO LOGIC are canceled.
7
ENGLISH