PLAY WITH DOLBY PRO LOGIC
kT
DOLBY
,— —_.._
___—
.
PRO
LOGIC
,.—___ _
a“
=-====–
~an[--
i,~)–
–--–
$:-g’i~%
—
—
—
—. —— .—
—
1 Start playback of the video source.
2 Press the DOLBY PRO LOGIC button.
NORMAL is selected, and the playback sound has the DOLBY
PRO LOGIC effect,
To cancel Dolby Pro Logic mode
Press the DOLBY PRO LOGIC button repeatedly until P-oFF is
displayed,
ADDITIONAL
DOLBY PRO LOGIC MODES
In addition to the NORMAL mode, this unit is also equipped with
the PHANTOM and the 3 CH LOGIC modes.
PHANTOM mode: Use this mode when no center speaker is
connected,
The center channel signals are output through the
left and right speakers.
3 CH LOGIC mode: Use this mode when no surround speakers
are connected. This mode reproduces rear sounds through the
front speakers.
To select PHANTOM or 3 CH LOGIC
Press the DOLBY PRO LOGIC button to run through the mode
choices for selection in the following sequence,
r
NORMAL
~
PHANTOM
~
3 CH LOGIC
7
I
cancel
J
10 adjust the balance of connected speaker sound levels
Carry out steps 2 to 4 on page 17.
Depending on the sound source and/or listening conditions, a
surround effect may not be obtained even when the DOLBY
PRO LOGIC is on.
The full DOLBY PRO LOGIC effect cannot be obtained when
using software without
BIOULEY
SURROUNLI
mark. In this case, use
the SURROUND system instead. (See page 7,)