Transport Safety; Installation Safety - Beko BDFN26640WC Manual

Remove the plug from the socket
by grasping the plug, not the
cable.
Transport security
Before transporting the
product, unplug it and
disconnect its drain and
water supply fittings.
Completely drain the water
remaining in the appliance.
The product is heavy, do
not move it alone.
REMARKAvoid moving the
appliance by holding it by the
door or by the control panel.
REMARKIf you need to move
the device, place it in an
upright position and hold it by
the sides. Tilting the product
forward may wet its electronic
components and damage
them.
REMARKTake care that the
pipes are not bent,
compressed or crushed
when placing the product
in its place after the
installation or cleaning
procedures.
Facility Security
•
Before installing the
appliance, review the
information in the user's
manual and the installation
instructions and make sure
that the electrical, water
supply and
6/FR
evacuation are appropriate.
If it's not the case,
contact a qualified technician
and plumber to have the
necessary arrangements
made. These procedures are
the responsibility of the
customer.
•
Before proceeding with the
installation, check whether the
product has any defects. If the
product is damaged, do not
have it installed.
•
Do not install the product in
environments where the
temperature is below 0 ºC.
Do not place the product on
carpets or similar surfaces.
This can cause a fire hazard
as the product will not be
vented from below.
Place the product on a clean,
flat and solid surface and
balance it using the
adjustable feet. If the feet are
not correctly adjusted, the
door will not be completely
closed and hot steam will
escape from the appliance.
This could cause serious
burns and injuries, and
damage your furniture.
Do not install the
product near heat
sources (heating,
stove, etc.) or under the
cooking zone of a hob.