Proper Care And Cleaning Of The Beer Dispenser; Installing The Cleaning Kit - Haier HBF05E - ANNEXE 519 Manual

Hide thumbs Also See for HBF05E - ANNEXE 519:
Table of Contents

Advertisement

Available languages

Available languages

English
Proper Care and Cleaning of the Beer
Dispenser

Installing the Cleaning Kit

Read and understand the following instructions before installing the cleaning kit.
1. Mix one gallon of warm water and one ounce (one
tablespoon) of cleaner in a bucket.
Note: Do not use lye, soap or hot water.
2. Remove the cleaner cap. Fill the jar and replace the cap.
Leave the remaining solution in the bucket.
3. Turn off either the air cock on the regulator or the valve on
the CO
tank.
2
4. Disconnect the tap from the barrel. Then disconnect the beer line from the tap
by turning the nut counter-clockwise. Place the tap and the end of the hose in
the bucket.
5. Remove the faucet from the tower with the wrench and attach the fitting on the
cleaning bottle in its place.
Note: Make sure there is a washer in the back of the fitting.
6. Hold the cleaning jar upside down until the solution runs through to the bucket
as shown in the above figure.
7. Fill the jar with cool clean water and repeat the process until the water runs
clear.
8. Rinse the tap in the bucket with cool water.
9. Remove the fitting from the tower and replace the faucet. Make sure the washer
is in the back of the faucet.
10. Re-attach the beer hose to the tap and attach the tap to the barrel.
Note: Beer lines should be flushed after each keg is emptied.
15

Advertisement

Table of Contents
loading

This manual is also suitable for:

Brewmaster hbf05e

Table of Contents