Timer On-Off Operation - Haier H3SM- - annexe 5 Operation Manual

Operation

Timer On-Off Operation

Remote Controller
TEMP
HEALTH
SWING
H.AIR.
MODE
SLEEP FRESH
CLOCK
TIMER
LOCK LIGHT CODE
Set clock correctly before starting TIMER operation.
1. After unit starts, select your desired operation mode
Operation mode will be displayed on LCD.
2. Timer mode selection
Press TIMER button to change TIMER mode. Every time
the button is pressed, display changes as follows:
Remote controller:
Then select your desired TIMER mode (TIMER ON - OFF).
"
3.Time setting
Press HOUR
Every time the button is pressed, time setting increases
1 min, if kept depressed, it will increase rapidly.
Every time the button is pressed, time setting decreases
1 min, if kept depressed, it will decrease rapidly.
It can be adjusted within 24 hours.
FAN
4.Timer confirming for TIMER ON
After setting correct time, press TIMER button to confirm
"
SET
"
Time displayed: Unit starts or stops at x hour x min.
5.Time setting for TIMER OFF
Just press HOUR button ,follow the same procedure in
RESET
"Time setting for TIMER ON"
6.Time confirming for TIMER OFF
After time setting,press SET button to confirm.
"
Time displayed:Unit stops at x hour x min.
To cancel TIMER mode
Just press TIMER button several times until TIMER
mode disappears.
According to the Time setting sequence of TIMER ON
or TIMER OFF, either Start-Stop or Stop-Start can be
achieved.
TIMER ON TIMER OFF
"will flash.
button.
" on the remote controller stops flashing.
" starts flashing.
" on the remote controller stops blinking.
17
BLANK
TIMER ON-OFF