Timer Operation - Haier AS25XCHHRA-NR Operation Manual

Operation
ECO SENSOR Operation
For each press,changes as follows:
The intelligent sensor can automatically
detect your position. Depending on your
choice, the unit can adjust the airflow in
2 different settings: "Follow me Mode"
setting guarantees that the air flow fol-
lows you, while "Avoid Mode" setting
will keep the air flow away from you.
The Eco Sensor can automatically iden-
tify the existance of the human being
to improve the user experience. The
air conditioner will switch to ECO mode
after 20 minutes while nobody is in the
room.
NOTE:
A human sensor is used to detect changes in the infrared radi-
ation emitted by human bodies. In case of the following condi-
tions, the detection may not be accurate:
1. High room temperature, where the ambient temperature is
close to body temperature.
2. People wear a lot or lie on their stomach or back.
3. The speed of human movement exceeds the sensitivity of
the sensor.
4. Frequent movements of pets, frequent swing of curtains or
other indoor objects due to the wind.
5. Moving targets go beyond the detection range of the sensor.
6. The left and right ends of the indoor unit are installed too
close to the wall.
7. There is direct sunlight inside the room.
8. The air conditioner operates in a room where ambient tem-
perature fluctuates sharply.
Besides, if a person is at the border of two air blowing areas,
the following air will be sent to these two areas respectively or
be swept automatically. The avoiding air will avoid these two
areas or be swept automatically.
Press ECO SENSOR button
cancel

TIMER Operation

TIMER
2.
Every time the button is pressed, time setting increases or
decreases 1 min, if kept pressed, it will increase rapidly. It can be
adjusted within 24 hours.
3.
Confirm timer setting
After adjust the time, press the button and confirm the
time ON or OFF button will not flash any more.
4.
Cancel timer setting
Press the button, the time display eliminated.
NOTE:
After replacing batteries or a power failure happens, time set-
ting should be reset. According to the time setting sequence of
TIME ON or TIME OFF, either Start-Stop or Stop-Start can be
achieved.
8
Set Clock correctly before starting Timer
operation. You can let unit start or stop
automatically at the following times:
Before you wake up in the morning,
get back from outside or after you fall
asleep at night.
1.
Select your desired operation
mode.
Select your desired TIME
ON.
Remote controller: "TIMER ON"will
flash.
Select your desired TIME
OFF.
Remote controller: "TIMER OFF"will
flash.
Time setting.