Connecting Inputs; Connecting Outputs; Connecting The Power Cord - Pioneer DJM-400 - CDJ-400 Package Operating Instructions Manual

Always turn off the power switch and disconnect the power plug from its outlet when making or changing connections.

CONNECTING INPUTS

Pioneer DJ CD players
Connect a DJ CD player's audio output connectors to one of the
channel 1 to 2 CD input connectors, and connect the player's control
cable to the corresponding channel's CONTROL connector.
Set the connected channel's input selector switch to [CD].
Analog turntable
To connect an analog turntable, connect the turntable's audio output
cable to one of the channel 1 to 2 PHONO/LINE input connectors. Set
the corresponding channel's PHONO/LINE switch to [PHONO], and
set the channel's input selector switch to [PHONO/LINE]. The DJM-
400's PHONO inputs support MM cartridges. Connect the turntable's
ground wire to the DJM-400's SIGNAL GND terminal.
Connecting other devices with line level output
To use a cassette deck or other CD player, connect the component's
audio output connectors to one of the channel 1 to 2 PHONO/LINE
input connectors. Then set the corresponding channel's PHONO/
LINE switch to [LINE], and the input selector switch to [PHONO/LINE].
Microphone
The MIC1 and MIC2 jacks can be used to connect microphones with
Ø6.3 mm phone plugs. Set MIC/AUX switch to [MIC] position.
Auxiliary input connectors
The MIC1 and MIC2 jacks can also be used together as a pair of stereo
line input connectors to connect a component equipped with line
level output connectors. Connect the component's L channel to MIC1
(AUX(L)) jack and the R channel to the MIC2 (AUX(R)) jack. Then set
the MIC/AUX switch to [AUX] (this connection requires the use of
Ø6.3 mm phone plugs).

CONNECTING OUTPUTS

Master output
This unit is furnished with MASTER OUT 1 and MASTER OUT 2
output systems, both of which support the use of RCA plugs.
If the unit's STEREO/MONO switch is set to [MONO], the master
output will be a monaural combination of L+R channels.
MIC/AUX switch
POWER
OFF ON
AC IN
MASTER
OUT
PHONO/LINE switch
Note:
Set switch to [LINE]
except when using
an analog turntable
Cassette deck, etc.
MIC2
MONO STEREO AUX(R)
MIC AUX
PHONO
CD
LINE
1 2
L L
LINE PHONO
R R
CONTROL
R L R
L R
Analog turntable
Headphones
The front panel PHONES jack can be used to connect headphones
with a Ø6.3 mm stereo phone plug.
Power amplifier
Cassette deck, etc.
(analog input recording
component)

CONNECTING THE POWER CORD

Connect the power cord last.
÷ After completing all other connections, connect the accessory
power cord to the AC inlet on the back of the player, then connect
the plug to a standard wall outlet or to the auxiliary power outlet
of your amplifier.
÷ Use only the supplied power cord.
MIC1
AUX(L)
PHONO
CD
LINE
SIGNAL
GND
L
LINE PHONO
R
CONTROL
L R L R L
Analog turntable
STEREO/MONO switch
MONO STEREO
POWER
OFF ON
AC IN
1 2
MASTER
OUT L
R
L R R L
Power amplfier
Input selector switches
R
L
Electronic instrument,
CD player, etc. (phone
plug connection)
DJ CD player DJ CD player
CONNECTIONS
Front panel
Headphones
Microphone 2
Microphone 1
5