Connecting Inputs - Pioneer DJM-800 Operating Instructions Manual

Always turn off the power switch and disconnect the power plug from its outlet when making or changing connections.

CONNECTING INPUTS

Pioneer DJ CD players
Connect a DJ CD player's audio output connectors to one of the
channel 1 to 2 CD input connectors or the channel 3 to 4 LINE input
connectors, and connect the player's control cable to the
corresponding channel's CONTROL connector.
Set the connected channel's DIGITAL/CD switch or DIGITAL/LINE
switch to either [CD] or [LINE], and set the input selector switch to
[CD/DIGITAL] or [LINE/DIGITAL].
When making digital connections, connect the digital coaxial output
terminal of the DJ CD player to one of the channel 1 to 4 DIGITAL IN
connectors of the DJM-800; then set the corresponding channel's
DIGITAL/CD switch or DIGITAL/LINE switch to [DIGITAL], and the
input selector switch to [CD/DIGITAL] or [LINE/DIGITAL].
Analog turntable
To connect an analog turntable, connect the turntable's audio
output cable to one of the channel 2 to 4 PHONO input connectors.
Set the corresponding channel's input selector switch to [PHONO].
The DJM-800's PHONO inputs support MM cartridges.
Connect the turntable's ground wire to one of the DJM-800's
SIGNAL GND terminals.
÷ Note that no PHONO input connector is provided for channel 1.
DIGITAL/LINE switch
MASTER 2
POWER
OFF ON
1GND
2HOT
3COLD
AC IN
Analog turntable
SIGNAL GND
REC PHONO LINE PHONO LINE
L L L
CONTROL
R R R
DIGITAL
LINE
MASTER ATT 0dB
-3dB
-6dB
-12dB
R L ADD CUT
MASTER 1
R
MIC SIGNAL
R L
L R
L R
Analog turntable
CONNECTIONS (CONNECTING INPUTS)
Connecting other line level output devices
To use a cassette deck or other CD player, connect the component's
audio output connectors to one of the channel 3 to 4 LINE input
connectors. Then set the corresponding channel's DIGITAL/LINE
switch to [LINE], and the input selector switch to [LINE/DIGITAL].
Alternately, connect the component to the channel 1 LINE input
connector, then set the channel 1 input selector switch to [LINE].
Connecting other digital output devices
To use a CD player or other component with digital connections,
connect the component's digital coaxial output connectors to one of
the channel 1 to 4 DIGITAL IN connectors; then set the corresponding
channel's DIGITAL/CD switch or DIGITAL/LINE switch to [DIGITAL],
and the input selector switch to [CD/DIGITAL] or [LINE/DIGITAL].
Input selector switch
SIGNAL GND
PHONO CD LINE CD
L L
CONTROL CONTROL
R R
DIGITAL DIGITAL
LINE CD
BOOTH L R L R
(MONO)
SEND RETURN
(TRS)
L R L R
L R
DJ CD player DJ CD player
DIGITAL/CD switch
DIGITAL IN
CONTROL
MIDI OUT
DIGITAL OUT
fs (Hz)
DIGITAL
CD
48 k 96 k
L
(MONO)
CD player, etc.
Cassette deck, etc.
5
<DRB1392>
En