Connecting Inputs - Pioneer DJM-800 Operating Instructions Manual

CONNECTIONS (CONNECTING INPUTS)
Always turn off the power switch and disconnect the power plug from its outlet when making or changing connections.

CONNECTING INPUTS

Pioneer DJ CD players
Connect a DJ CD player's audio output connectors to one of the
channel 1 to 2 CD input connectors or the channel 3 to 4 LINE input
connectors, and connect the player's control cable to the
corresponding channel's CONTROL connector.
Set the connected channel's DIGITAL/CD switch or DIGITAL/LINE
switch to either [CD] or [LINE], and set the input selector switch to
[CD/DIGITAL] or [LINE/DIGITAL].
When making digital connections, connect the digital coaxial output
terminal of the DJ CD player to one of the channel 1 to 4 DIGITAL IN
connectors of the DJM-800; then set the corresponding channel's
DIGITAL/CD switch or DIGITAL/LINE switch to [DIGITAL], and the
input selector switch to [CD/DIGITAL] or [LINE/DIGITAL].
Analog turntable
To connect an analog turntable, connect the turntable's audio
output cable to one of the channel 2 to 4 PHONO input connectors.
Set the corresponding channel's input selector switch to [PHONO].
The DJM-800's PHONO inputs support MM cartridges.
Connect the turntable's ground wire to one of the DJM-800's
SIGNAL GND terminals.
÷ Note that no PHONO input connector is provided for channel 1.
DIGITAL/LINE switch
MASTER 2
POWER
OFF
ON
1GND
2HOT
3COLD
AC IN
Analog turntable
6
SIGNAL GND
PHONO LINE PHONO
REC
L L L
CONTROL
R R R
DIGITAL
LINE
MASTER ATT 0dB
-3dB
-6dB
-12dB
R L ADD CUT
MASTER 1
MIC SIGNAL
L R R L
L R
Analog turntable
Connecting other line level output devices
To use a cassette deck or other CD player, connect the component's
audio output connectors to one of the channel 3 to 4 LINE input
connectors. Then set the corresponding channel's DIGITAL/LINE
switch to [LINE], and the input selector switch to [LINE/DIGITAL].
Alternately, connect the component to the channel 1 LINE input
connector, then set the channel 1 input selector switch to [LINE].
Connecting other digital output devices
To use a CD player or other component with digital connections,
connect the component's digital coaxial output connectors to one of
the channel 1 to 4 DIGITAL IN connectors; then set the corresponding
channel's DIGITAL/CD switch or DIGITAL/LINE switch to [DIGITAL],
and the input selector switch to [CD/DIGITAL] or [LINE/DIGITAL].
÷ The sound may be temporarily interrupted when the output
signal's sampling frequency is changed.
Input selector switch
SIGNAL GND
LINE PHONO CD LINE
L L
CONTROL CONTROL
R R
DIGITAL DIGITAL
LINE CD
R BOOTH L R L
(MONO)
SEND
(TRS)
L R L
L R
DJ CD player DJ CD player
DIGITAL/CD switch
DIGITAL IN
CD
CONTROL
MIDI OUT
DIGITAL OUT
fs (Hz)
DIGITAL
CD
48 k 96 k
L
R
(MONO)
RETURN
R
CD player, etc.
Cassette deck, etc.