Delay; Chorus; Phaser - Xils lab PolyKB III User Manual

6.6.1

Delay

Dry/Wet: set the mix level between the initial signal and the processed signal
Time: set the time delay (right or left)
Feedback: set the amount of the delayed signal which is reused (left and right)
Sync: set the time delay according to the tempo (the time will change each time the current tempo of the
host application changes)
6.6.2

Chorus

Dry/Wet: set the mix level between the initial signal and the processed signal
Rate: set the rate of the internal low frequency oscillator of the chorus.
Amount: set the amount of the effect.
Type: select the type of the chorus within three different treatments.
6.6.3

Phaser

Dry/Wet: set the mix level between the initial signal and the processed signal
Speed: set the rate of the internal low frequency oscillator of the phaser.
Amnt: set the amount of the effect, meaning how deep the sweep of the internal filter will be.
Freq: set the middle frequency around which the sweep is done.
Res: set the amount of the internal audio feedback.
Stereo : set the difference of phase between the right and the left channel.
6.6.4 EQ
The EQ section provides two High/Low shelf filters, designed to avoid any artifacts near the Nyquist
frequency, allowing an analog feeling and a very clear sound.
Freq: set the cutoff frequency.
Res: set the quality on the filter.
Gain: set the level of the shelf. ( Centered knob, turning it clockwise will increase the frequency
content specified, while turning it anti clockwise will lower the specified frequency content )
ON Led : enables the filter. ( When Lit = Green )
Please note that to be active, both the EQ switch diode (Red) and at least one of the two EQs ON diodes
(Green) should be lit. Then at least one of the two Gain knobs should have a value different than center.