Listening To A Source - Yamaha TSX-20 Owner's Manual

LISTENING TO A SOURCE

This chapter explains the basic operations common to
tuning, playing CDs and other connected components.
STANDBY/ON
STANDBY/ON OPEN/CLOSE
NATURAL SOUND
MEMORY AUTO/MAN´L PRESET/BAMD
TIME ADJ TIMER
PHONES SLEEP DISPLAY
PRESET STEREO
TIMER SLEEP MEMORY
PHONES
SLEEP
B. BOOST
B. BOOST
BASS/TREBLE
BASS/
FREQ/RDS
TREBLE
TUNER
PRESET
MUTE
MUTE
VOLUME
PRESET/TUNING
HOUR
CD RECEIVER
INPUT
SNOOZE
AUTO RDS PSPTYRTCT REP TOTAL PROG TONE
TUNED PTY HOLD S F RANDOM B. BOOST
MIN
A/B/C/D/E
INPUT
STANDBY/ON
STANDBY/ON
LEVEL
LEVEL –/+
RTY SEEK
MODE START
PRESET
ABCDE
INPUT
INPUT
DISPLAY
VOL
VOLUME +/–
1
Turn on the power by pressing STANDBY/ON.
2
Select the desired input source by pressing INPUT
repeatedly until the source appears on the display.
• When you operate the component connected to the
LINE IN terminal, select AUX.
3
Play the source. (Refer to the instructions of each
selected component.)
4
Adjust the volume level by turning VOLUME on the
main unit or pressing VOLUME +/– on the remote
control.
Sound controls
You can perform various sound controls using the remote
control. These controls and VOLUME adjustment have no
effect on the material being recorded with the component
HOUR
connected to the LINE OUT terminal.
MUTE:
MIN
You can mute the sound.
Press MUTE.
•
"Mute" appears on the display.
Pressing the button again cancels this feature.
BASS/TREBLE:
You can adjust the level of low frequency response
(BASS) and high frequency response (TREBLE).
1 Press BASS/TREBLE repeatedly until "BASS
0dB" or "TREBLE
display.
2 Press LEVEL –/+ to adjust the level.
The value increases or decreases in steps of 2 dB.
Control range: –10dB to +10dB (Preset value:
B. BOOST (Bass boost):
You can reinforce the bass frequency response.
Press B.BOOST.
•
The "B.BOOST" indicator lights up on the display.
Pressing the button again cancels this feature.
When you use headphones
Connect the headphones to the PHONES jack. You can
listen to the sound to be output from the speakers through
the headphones.
When you have finished using this
unit
Press STANDBY/ON to set this unit to the standby mode.
• The brightness of the display decreases.
0dB" appears on the
0dB)
13