Remote Control - Yamaha TSX-20 Owner's Manual

Remote control

I Loading the battery for the remote
control
2
1
Slide out the battery holder from the remote control
by pushing into the hole in the holder with a ball-point
pen, etc.
2
Place the battery in the holder, positive side upward.
3
Slide the holder into the remote control.
I Battery replacement
If you find that the remote control must be used closer to
the main unit than usual, the battery is weak. Replace the
battery with new one.
I Notes on the lithium battery
Please take care when using the lithium battery as it may
explode if mistreated.
●
Never abuse or disassemble the battery.
●
Be sure the battery polarity is correct. If it is not
installed correctly, it may cause fire or explosion.
●
Avoid placing the lithium battery and also the remote
control with the battery installed, in high temperature
such as direct sunlight.
●
Do not recharge the battery.
●
When replacing the battery, make sure to only use a
CR2025 battery.
●
Keep the battery out of reach of children. If swallowed,
get immediate medical help.
●
When disposing of the battery, insulate it with tape, etc.
Never dispose of it in fire. Also, dispose of the battery
according to local regulations.
●
If the battery leaks, dispose of it immediately. Avoid
touching the leaked material or letting it come in
contact with clothing, etc. Skin contact may cause burn.
If it occurs, wash with water promptly and get medical
attention.
3
1
GETTING STARTED
I Remote control operation range
When the unit is hung on the wall, or installed with the
stands, set the remote control sensor switch to the
OTHER position. When using the unit installed
horizontally, set the switch to the HRIZ position.
Remote control sensor switch
In the OTHER position
TIME ADJ TIMER
Remote control
sensor
Notes
● There should be no large obstacles between the remote control
and the main unit.
● If the remote control sensor is directly illuminated by strong
lighting (especially an inverter type of fluorescent lamp, etc.),
it might cause the remote control not to work correctly. In this
case, reposition the main unit to avoid direct lighting.
● If you install the unit horizontally and operate with the remote
control from a higher position than the unit, setting the remote
control sensor switch to OTHER may improve the response.
HRIZ OTHER
In the HRIZ position
Within approximately
6 m (20 feet)
11