D-Link DSL-320T User Manual page 31

To configure a Static IP connection for the WAN, follow these steps:
1. Click the Static IP Address radio button in the WAN Settings section in the middle of the window.
2. The settings under ATM VC Setting at the top of the window should not be changed unless you have been
instructed to change them. However, if you are instructed to change the VPI or VCI values, type in the values
assigned for your account. Leave the Virtual Circuit setting at the default (Enabled) value for now.
3. Under the Static IP heading, choose the Connection Type from the pull-down menu. This defines both the
connection type and encapsulation method used for your ADSL service. The available options are Routed IP
LLC and Routed IP VC-Mux. If you have not been provided specific information for the Connection Type,
leave the default setting.
4. Change the IP Address, Subnet Mask, Gateway Address and (if available) Secondary DNS Address as
instructed by your ISP. These are the global IP settings for the WAN interface. This is the "visible" IP address
of your account. Your ISP should have provided these IP settings to you.
5. Leave the MTU value at the default setting (default = 1400) unless you have specific reasons to change this
(see table below).
6. Most users will not need to change ATM settings. If this is the first time you are setting up the ADSL
connection it is recommended that you leave the Service Category settings at the default values until you have
established the connection. See the table on page 23 for a description of the parameters available for ATM
traffic shaping.
7. When you are satisfied that all the WAN settings are configured correctly, click on the Apply button.
8. To save and reboot the Modem, click on the Tools directory tab and then click System. Next click the Save
and Reboot button in the lower half of the System Settings window.
9. Click OK when the following "Save and restart?" dialog box opens.
10. The Modem will save the new settings and restart. Upon restarting the Modem will automatically establish the
WAN connection.
The following provides additional description of the settings for Static IP Address connections:
Static IP Parameters
Connection Type
IP Address
Subnet Mask
Gateway Address
DSL-320T ADSL Modem User Guide
Description
This specifies the connection type and the encapsulation method used for
your Static IP Address connection. The options available are
IP LLC 1483 Routed IP VC-Mux
and
This is the permanent global IP address for your account. This is the
address that is visible outside your private network. Get this from your ISP.
This is the Subnet mask for the WAN interface. Get this from your ISP.
This is the IP address of your ISP's Gateway router. It provides the
21
.
1483 Routed