Yamaha HTR-6130 Owner's Manual page 36

Playback
■ Adjusting speaker levels during
playback
You can adjust the output level of each speaker while
listening to a music source.
Note
This operation will override the level adjustment made in "SP
LEVEL" (see page 46).
Press 4 AMP and then press 6 LEVEL
1
repeatedly to select the speaker you want to
adjust.
Display
FRONT L
Front left speaker
FRONT R
Front right speaker
CENTER
Center speaker
SWFR
Subwoofer
SUR.L
Surround left speaker
SUR.R
Surround right speaker
y
Once you press 6 LEVEL on the remote control, you can
also select the speaker by pressing 7 k / n.
2
Press 7 l / h on the remote control to
adjust the speaker output level.
The control range is from –10 dB to +10 dB.
y
You can press D A/B/C/D/E to select a speaker and then
E PRESET/TUNING l / h to adjust the speaker output level.
32
En
Adjusted speaker
■ Displaying the signal information
You can display the format, sampling frequency, channel,
bit rate and flag data of the current input signal.
Press 4 AMP and then press H MENU on
1
the remote control.
"BASIC SETUP" appears in the front panel display.
;BASIC SETUP
2
Press 7 k / n repeatedly to select "SIGNAL
INFO" and then press 7 ENTER.
3
Press 7 k / n to switch the displayed
information.
The following information about the input source
appears in the front panel display.
Display
Format Signal format.
Sampling
The number of samples per second taken
frequency
from a continuous signal to make a discrete
signal.
Channel The number of source channels in the input
signal (front/surround/LFE).
Bit rate The number of bits passing a given point
per second.
Flag data Flag data encoded in DTS, Dolby Digital,
or PCM signals that cue this unit to
automatically switch decoders.
Press H MENU to exit.
4
Description