Message List; Error Message - Yamaha HTR-5063 Owner's Manual

Owners manual
Hide thumbs Also See for HTR-5063:
Table of Contents

Advertisement

Message list

NOTE
If the following messages appear, resolve the problems that have
occurred and carry out the measurement process again.
■ When a warning message appears before
measurement
Connect MIC!
The YPAO microphone is
not connected.
Unplug HP!
The headphones are
connected.
Memory Guard!
The settings of this unit
are protected.

■ Error message

E-1:
NO FRONT SP
E-2:
NO SUR. SP
E-4:
SBR.SBL
Connect the YPAO
microphone to the YPAO
MIC jack on the front
panel.
E-5:
Remove the headphones.
NOISY
Set "Memory Guard" in
the Setup menu to "Off"
(☞p.
59).
E-6:
CHECK SUR.
The unit was not able to
Check that the left and
find the front channel.
right front speakers are
connected correctly.
The unit was only able to
Check that the left and
find one of side of the
right surround speakers
surround channels.
are connected correctly.
Only one surround back
When only one surround
speaker is connected and
back speaker is
only the right side
connected, connect to the
surround back channel
left side (SINGLE)
sound is detected.
terminal.
The noise is too loud,
Measure again in quiet
preventing accurate
surroundings. Turn off any
measurements from
devices in the room that
being taken.
may be emitting noise, or
place them further away
from the YPAO
microphone.
When this message is
displayed, selecting
"Proceed" will allow you
to continue measuring.
However, we recommend
resolving the problem and
measuring again, as
continuing measurement
without doing so will not
give accurate results.
Even though surround
When using surround back
left and right speakers are
speakers, connection of the
not connected, only the
surround left/right
surround back speakers
speakers is necessary.
are connected.
CONNECTIONS
Set up the speaker parameters automatically (YPAO)
E-7:
The YPAO microphone
While measuring, take
NO MIC
has been removed.
care not to touch the
YPAO microphone.
E-8:
The YPAO microphone
Check that the YPAO
NO SIGNAL
could not distinguish a
microphone has been
test tone.
installed correctly.
Check that each speaker
has been connected and
installed correctly.
The YPAO microphone
or the YPAO MIC jack
may be broken. Inquire at
the retailer where you
purchased this unit, or the
nearest Yamaha service
center.
E-9:
You have carried out an
Carry out the measuring
USER CANCEL
operation that has
process again. Do not
cancelled the measuring
operate this unit by, for
process.
example, adjusting the
volume.
E-10:
An internal error has
Carry out the measuring
INTERNAL ERROR
occurred.
process again. Contact a
Yamaha service center if
"E-10" appears again.
27
En

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Htr5063blRx-v567

Table of Contents