Yamaha HTR-5063 Owner's Manual page 53

■ Adjusting the graphic equalizer
When "EQ Type Select" is displayed, use
1
jCursor D / E
to select "GEQ" and press
jENTER.
2 Check that "Channel" selects and use
/ E
to select the speaker for which you want to
adjust the equalizer.
;
Equalizer
. Channel;;;;Front L
63Hz ;;;;;;||;;;;;; 0dB
160Hz ;;;;;;||;;;;;; 0dB
400Hz ;;;;;;||;;;;;; 0dB
1kHz ;;;;;;||;;;;;; 0dB
2.5kHz ;;;;;;||;;;;;; 0dB
6.3kHz ;;;;;;||;;;;;; 0dB
16kHz ;;;;;;||;;;;;; 0dB
[p]/[[]:Select
Frequency band Setting the volume level for
the selected frequency
jCursor C
Press
3
frequency you want to adjust, then use
/ E
to adjust the volume.
Raising volume:
Lowering volume: Press
jCursor D
Frequency 63 Hz/160 Hz/400 Hz/1 kHz/2.5 kHz/6.3 kHz/
range 16 kHz
Adjustable -6.0 dB to 0 dB to +6.0 dB
range
Default setting 0 dB
Speaker
Adjustment
0.5 dB
increments
jCursor B / C
You can use
return to step 2. Repeat steps 2-3 to adjust the tone to your
liking.
When you have finished making adjustments,
4
iSETUP
press
repeatedly to select the
jCursor D
j E.
Press Cursor
j D.
Cursor
to select another frequency or
to close the Setup menu.
Setting various functions (Setup menu)
■
Generating test tones
Test Tone
Turns the test tone generator on or off.
Off (Default) Does not generate test tones.
On Generates test tones. While "On" is selected, test
tones are produced constantly.
You can use the test tone in a variety of circumstances. For
example, you can adjust the volume balance settings for each
speaker, or whenever you adjust the settings on the internal
graphic equalizer, you can listen to the actual effect while
operating this unit. Turn the test tone off when you have finished
making adjustments.
SETUP
53
En