Message List; Error Message - Yamaha RX-V367 Owner's Manual

■

Message list

NOTE
If the following messages appear, resolve the problems that have
occurred and carry out the measurement process again.
■ When a warning message appears before
measurement
Connect MIC! The YPAO microphone is
not connected.
Unplug HP! The headphones are
connected.
Memory Guard! The settings of this unit
are protected.

■ Error message

E-1:FRONT SP The unit was not able to
find the front channel.
E-2:SUR. SP The unit was only able to
find one of side of the
surround channels.
E-5:NOISY
Connect the YPAO
microphone to the YPAO
MIC jack on the front
panel.
Remove the headphones.
Set "Memory Guard" in
E-7:NO MIC
the Setup menu to "Off."
E-8:NO SIGNAL
Check that the left and
right front speakers are
connected correctly.
Check that the left and
right front surround
speakers are connected
correctly.
E-9:CANCEL
E-10:INTERNAL
The noise is too loud, Measure again in quiet
preventing accurate surroundings. Turn off any
measurements from devices in the room that
being taken. may be emitting noise, or
place them further away
from the YPAO
microphone.
When this message is
displayed, selecting
"Proceed" will allow you
to continue measuring.
However, we recommend
resolving the problem and
measuring again, as
continuing measurement
without doing so will not
give accurate results.
The YPAO microphone While measuring, take
has been removed. care not to touch the
YPAO microphone.
The YPAO microphone Check that the YPAO
could not distinguish a microphone has been
test tone. installed correctly.
Check that each speaker
has been connected and
installed correctly.
The YPAO microphone
or the YPAO MIC jack
may be broken. Inquire at
the retailer where you
purchased this unit, or the
nearest Yamaha service
center.
You have carried out an Carry out the measuring
operation that has process again. Do not
cancelled the measuring operate this unit by, for
process. example, adjusting the
volume.
An internal error has Carry out the measuring
occurred. process again. Contact a
Yamaha service center if
"E-10" appears again.
CONNECTIONS
Set up the speaker parameters automatically (YPAO)
■ Warning message
W-1:PHASE The speakers displayed
are connected with the
opposite polarity.
Depending on the type of
speakers you are using
and the environment in
which you have them
installed, this message
may occur even if the
speakers are connected
correctly.
W-2:OVER 24m
The speakers displayed
(80ft) are separated from the
listening position by
more than 24m, and
cannot be adjusted
correctly.
W-3:LEVEL The difference each
channel is too loud or too
low, and cannot be
adjusted correctly.
If "W-2" or "W-3" appears, you can apply measurement results,
but they will not give optimal results. We recommend that you
resolve the problem and carry out the measurement process
again.
Depending on the type of
speakers, "W-1" may
display even if the
speakers are connected
correctly.
Check that the speaker
polarity + (plus), and -
(minus) are correct. If
these are connected
correctly, you can use the
speakers normally even
this message appears.
Install the speakers with
24m of the listening
point.
Check that all speakers
are installed in the same
surroundings.
Check that the speaker
polarity + (plus), and -
(minus) are correct.
We recommend the same
speakers or speakers with
as similar specifications
as possible.
Adjust the volume of the
subwoofer.
24
En