Appendix; Troubleshooting; General - Yamaha HTR-5063 Owner's Manual

Owners manual
Hide thumbs Also See for HTR-5063:
Table of Contents

Advertisement

APPENDIX

Troubleshooting

Refer to the table below when this unit does not function properly.
If the problem you are experiencing is not listed below, or if the instructions below do not help, turn off this unit, disconnect the power cable, and contact the nearest authorized Yamaha dealer or service
center.

General

Problem
Cause
The power will not
The protection circuitry operated
turn on.
3 times consecutively.
The unit enters
The power cable is not completely
standby mode soon
inserted.
after the power is
(When this unit is turned back on
turned on.
and "CHECK SP WIRES!" is
displayed.) The protection
circuitry has been activated
because this unit was turned on
while a speaker cable was shorted.
This unit cannot be
The internal microcomputer is
turned off or does
hung-up due to an external electric
not work properly.
shock (such as lightning or
excessive static electricity) or by a
drop in power supply voltage.
The batteries in the remote control
may have lost their charge.
The unit enters
The protection circuitry has been
standby mode.
activated because of a short circuit,
etc.
See
Remedy
page
As a safety precaution, when the protection
circuitry operates 3 times consecutively, the
capability to turn on the power is disabled.
Please contact your nearest Yamaha dealer
or service center to request repair.
Connect the power cable properly to an AC
wall outlet.
Make sure that all speaker cables between
12
this unit and speakers are connected
properly.
Disconnect the power cable from the AC
wall outlet, wait about 30 seconds and then
plug it in again.
Replace all batteries.
4
Check that the speaker with an impedance
of at least 6Ω.
(U.S.A. and Canada models)
12
Check that the speaker impedance settings
are correct.
Problem
Cause
After display of a
If you do not use take any action,
countdown on the
the Auto Power Down function
front panel, the unit
operates.
goes into standby
mode.
Sound/images
The protection circuitry has been
suddenly go off.
activated because of a short circuit,
etc.
The sleep timer has turned off the
unit.
See
Remedy
page
Turn on the unit, and play the source again.
In the Setup menu "AutoPowerDown"
59
("Function Setup" → "AutoPowerDown"),
increase the time until switching to standby
mode, or turn off the Auto Power Down
function.
Check that the speaker wires are not
touching each other, then turn the unit back
on.
Turn on the unit, and play the source again.
71
En

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Htr5063blRx-v567

Table of Contents