Placing And Assembly Of Your Refrigerator >5; Preparation; Points To Be Considered When Transporting The Product - Beko DNE 61100 DPX - ANNEXE 205 Manual

3 Placing and assembly of your refrigerator
• Please remember that the
manufacturer shall not be held liable
if the information given in the
instruction manual is not observed.
This product is designed for
domestic use.
Prior to operating your refrigerator,
please read the instruction manual
carefully that includes important
information such as installation,
usage and maintenance of your
product.

Preparation

Your refrigerator should be installed at
least 30 cm away from heat sources
such as hobs, ovens, central heater
and stoves and at least 5 cm away
from electrical ovens and should not be
located under direct sunlight.
• The ambient temperature of the
room where you install your refrigerator
should at least be 10°C. Operating your
refrigerator under cooler conditions than
this is not recommended with regard to
its efficiency.
• Please make sure that the interior of
your refrigerator is cleaned thoroughly.
• If two refrigerators are to be installed
side by side, there should be at least 2
cm distance between them.
• Your refrigerator must run smoothly
without any vibration. To ensure
this, maintain the balance of your
refrigerator on the floor by turning
the adjustable front legs clockwise
or counterclockwise. This should be
done before the food is placed in the
refrigerator.
• When you operate your refrigerator
for the first time, please observe the
following instructions during the initial six
hours.
- Temperature adjustment button should
not be turned off.
- The door should not be opened
frequently.
- It must be operated empty without any
food in it.
- Do not unplug your refrigerator; if a
power failure occurs out of your control,
please see the warnings in section
"Things to be done before calling the
authorized service".
• Original packaging and foam materials
should be kept for future transportations
or moving.
Points to be considered when
transporting the product:
1. Your refrigerator must be emptied and
cleaned prior to any transportation.
2. Shelves, accessories, crisper and etc.
in your refrigerator must be fastened
securely by adhesive tape against any
jolt before repackaging.
3. Packaging must be tied with thick
tapes and strong ropes and the rules of
transportation printed on the package
must be followed.
Please remember...
Every recycled material is an
indispensable source for the nature and
for our national resources.
If you wish to contribute to recycling the
packaging materials, you can get further
information from the environmental
bodies or local authorities.
5 EN