During First Use; Locking/Unlocking The Control Panel; Setting The Temperature Range; Setting The Temperature - Temptech OZ60DB-24 User Manual

Table of Contents

Advertisement

„ During First Use
IMPORTANT: When you use the Wine Cooler for the first time or restart the
appliance after it has been turned off for a long time, there could be a few
degrees variance between the temperature you set and the one indicated
on the LED display (If it is set to display Actual Temperature). This is normal
and it is due to the length of activation time. Once the Wine Cooler has
been running for a few hours everything will be back to normal.
o When you first switch on the appliance, the compressor will run
continuously until the Wine Cooler reaches a cool enough temperature.
o During this period of time, you should try not to open the door frequently
or place bottles inside of the appliance.
o If the unit is switched off or unplugged, you must allow at least 5 minutes
before restarting the appliance or reconnecting it to your mains supply.
„ Locking/Unlocking The Control Panel
o To lock the control panel, press the lock button for 3 seconds, the lock
mark
on the screen will be light on with a beep sounded;
o To unlock the control panel, press the lock button 3 seconds, the lock
mark
on the screen will be light off with a beep sounded;
o Note: System will be in unlocking state by default once the appliance is
powered up and energized. Indicator LED9 lights when system is locked.
System has no automatic locking and no automatic memory either.
„ Setting The Temperature Range
oThe temperature range, the range of Upper Zone is 5-12ºC (41-54 ºF) ,and
12-20 ºC 54-68 ºF) for lower Zone.
„ Setting The Temperature
o Make sure the Control Panel is under unlocked condition, press the
Temp. Zone Button to select Upper Zone or Lower Zone, the digital
on the Upper Zone or Lower Zone selected will start to flash;
o The digital
Temperature Plus or Minus button;
o When the digital
the digital will be increased by 1°C/1°F with a sound of beep.
will show the previous set temperature for the first press of
is flashing, press the Temperature Plus Button once,
.09.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the OZ60DB-24 and is the answer not in the manual?

This manual is also suitable for:

Oz60dx-24Oz90db-24Oz90dx-24Oz124db-24

Table of Contents