Table of Contents
Advertisement
Available languages
Available languages
Installing 2.5-inch Hard Drives
1. Remove the fastening pin as shown.
Note: Removed fastening pins can be attached in fixed holes near the tray covering incase they are
needed for 3.5-inch hard drives.
2. Place drive on the tray so that the holes on the bottom of the drive are aligned with the holes on the tray.
Hard drive pins
face down
7
3. Turn the tray upside down and tighten the screws to secure the drive in place. Then insert loaded
drive tray into empty drive bay and push the handle to fasten in place.
8
Advertisement
Table of Contents
Need help?
Do you have a question about the NASync DXP4800 Plus and is the answer not in the manual?
Questions and answers
When away from my desktop and out of range of my WIFI, how do I reconnect my mobile device to my UGreen DXP4800 Plus Server? Can I access it via Cellular instead of WIFI? All my devices work great under the control of my WIFI but when I'm remote I can't get access using my mobile device...
You can reconnect your mobile device to the UGREEN NASync DXP4800 Plus server remotely by enabling remote access. The NAS provides remote access to files from anywhere in the world. To do this, go to the control panel, navigate to device connection settings, and enable remote access.
Yes, you can access the NAS via cellular data instead of Wi-Fi, as long as remote access is enabled and the NAS is connected to the internet. However, enabling remote access comes with security risks, so proceed with caution.
This answer is automatically generated
I notice there are two Modes - Mode 1 UGreenlink remote access (It is checked)... Do I need Mode 2 to be enabled? And if so, how do I configure it?
How can I set up local access on my DXP4800 Plus?