Table of Contents
Advertisement
Available languages
Available languages
Unlocking Hard Drive Tray
Use the key to unlock the hard drive tray, and press the buckle to pop the handle out, then pull the tray out.
Installing 3.5-inch Hard Drives
1. Flip tray to the back, press buckle with the
"Press" icon to pull the clamp arm.
5
a
b
2. Place hard drive on the tray following the
angle shown in the figure. Ensure the four
fastening pins on the tray (two on each side)
are aligned with the screw holes on the
hard drive.
c
3. Push back the clamp arm to secure hard drive. Then insert loaded drive tray into empty drive bay and
push the handle to fasten in place.
Pull the
clamp arm
a
Hard drive pins
b
6
Advertisement
Table of Contents
Need help?
Do you have a question about the NASync DXP4800 Plus and is the answer not in the manual?
Questions and answers
When away from my desktop and out of range of my WIFI, how do I reconnect my mobile device to my UGreen DXP4800 Plus Server? Can I access it via Cellular instead of WIFI? All my devices work great under the control of my WIFI but when I'm remote I can't get access using my mobile device...
You can reconnect your mobile device to the UGREEN NASync DXP4800 Plus server remotely by enabling remote access. The NAS provides remote access to files from anywhere in the world. To do this, go to the control panel, navigate to device connection settings, and enable remote access.
Yes, you can access the NAS via cellular data instead of Wi-Fi, as long as remote access is enabled and the NAS is connected to the internet. However, enabling remote access comes with security risks, so proceed with caution.
This answer is automatically generated
I notice there are two Modes - Mode 1 UGreenlink remote access (It is checked)... Do I need Mode 2 to be enabled? And if so, how do I configure it?
How can I set up local access on my DXP4800 Plus?