Table of Contents
Advertisement
Available languages
Available languages
Product Overview
Safety Lock
Power Button
Power Indicator
Network Indicator
Hard Drive Indicator
3
USB 3.2 Gen 2 Port
Type-C USB 3.2 Gen 2 Port
SD Card Slot
Magnetic
Dust Mesh Filter
HDMI Port
USB 3.2 Gen 1 Port
2×USB 2.0 Port
2.5GbE Ethernet Port
10GbE Ethernet Port
Panel (Loosen the
screws to remove it)
QR Code (For
Binding Device)
Warning
Before inserting or removing any hard drive (including M.2 SSDs) / memory
module, please power off the system completely: turn off NAS and disconnect it
from power supply.
Power Port
Reset Hole
2×M.2 Slot
(optional)
2×Memory Slot
(with one
memory module
pre-installed)
4
Advertisement
Table of Contents
Need help?
Do you have a question about the NASync DXP4800 Plus and is the answer not in the manual?
Questions and answers
When away from my desktop and out of range of my WIFI, how do I reconnect my mobile device to my UGreen DXP4800 Plus Server? Can I access it via Cellular instead of WIFI? All my devices work great under the control of my WIFI but when I'm remote I can't get access using my mobile device...
You can reconnect your mobile device to the UGREEN NASync DXP4800 Plus server remotely by enabling remote access. The NAS provides remote access to files from anywhere in the world. To do this, go to the control panel, navigate to device connection settings, and enable remote access.
Yes, you can access the NAS via cellular data instead of Wi-Fi, as long as remote access is enabled and the NAS is connected to the internet. However, enabling remote access comes with security risks, so proceed with caution.
This answer is automatically generated
I notice there are two Modes - Mode 1 UGreenlink remote access (It is checked)... Do I need Mode 2 to be enabled? And if so, how do I configure it?
How can I set up local access on my DXP4800 Plus?