Satco NUVO 65-750 Installation And Safety Instructions

LED SMALL ROUND
WALL PACK
Models: 65-750, 65-751, 65-752
INSTALLATION AND SAFETY INSTRUCTIONS
IMPORTANT: Read before installing fixture. Retain for future reference.
WARNING: Risk of Fire or Electric Shock
• To reduce the risk of personal injury or property damage from fire,
electric shock, falling parts, cuts/abrasions, and other hazards
read all warnings and instructions included with and on the fixture
and all fixture labels.
• Commercial installation, service and maintenance of luminaries
should be performed by a qualified licensed electrician. If you are
unsure about the installation or maintenance of the luminaries, consult
a qualified licensed electrician and check your local electrical code.
• Turn OFF power at fuse or circuit breaker before wiring fixture to the
power supply.
• Turn OFF power when you perform any maintenance.
• All connections should be capped with UL approved wire connectors.
• Risk of Burn. Make sure to disconnect power and allow fixture to cool
before handling.
• Verify that supply voltage is correct by comparing it with the luminaire
label information. Minimum 75°C supply conductor.
• Do not install in a hazardous atmosphere, except where the ambient
temperature does not exceed the rated operating temperature of
the fixture.
• Keep tightly closed when in operation.
Item No. Color
65-750 BLACK
65-751 BRONZE
65-752 WHITE
INSTALLATION: Mounting Plate
STEP 1: Turn power OFF. Remove
the 4 screws.
© Copyright 2020 Satco Products, Inc. 9/20
Watts Volts
20W 120V-277V 3000K/4000K/5000K
20W 120V-277V 3000K/4000K/5000K
20W 120V-277V 3000K/4000K/5000K
STEP 2: Remove the 1/2"
end cap.
CCT
1
8 3/4" (220.9mm) Diameter
WIRING DIAGRAM
Fixture
STEP 3: Peel the yellow sticker
off the gasket and paste gasket
on the round bottom plate.
Satco Products, Inc.
Brentwood, NY 11717