Advertisement
Quick Links
___________________________________________________________________
www.bro-tek.com
_______________________________________________________________________
1.
Introduction:
A. Proud Owner:
. You are now the proud owner of a Bro-Tek Wheel Spacers.
These Wheel Spacers are made for your Husqvarna tractor rear axle.
It will outlast your original Husqvarna tractor & be ready for
your next one. Please read these instructions, before installing
the Wheel Spacers. The Wheel Spacers have been designed for easy
installation on your Husqvarna. Wheel Spacers are a bolt-on item.
Unit will be shipped complete in a box, all hardware included.
Important
Wheels, lift deck to max & measure to the back wheel clearence.
B. Feedback:
. We would love any feedback that you could give us
(Positive/Negative), to improve our product line.
Please email us your comments/pictures too:
bro-tek@hotmail.com
2.
Safety Precautions:
A. Park on a firm level area.
B. Stop engine, set parking brake, remove key and wait for all
moving parts to stop before servicing, adjusting or unplugging.
C. Block up before working beneath unit.
Save these
TS 354 XD
If you have a Mid Mount Mower , Please check clearances with the back Scalp
or you can reach us at
Important Safety
Instructions/Safety Manual
Bro-Tek@hotmail.com
www.bro-tek.com
owner/operator/installer
_________
Advertisement
Related Manuals for Husqvarna Bro-Tek RS 354 XD
Summary of Contents for Husqvarna Bro-Tek RS 354 XD
- Page 1 A. Proud Owner: . You are now the proud owner of a Bro-Tek Wheel Spacers. These Wheel Spacers are made for your Husqvarna tractor rear axle. It will outlast your original Husqvarna tractor & be ready for your next one. Please read these instructions, before installing the Wheel Spacers.
- Page 2 ___________________________________________________________________ www.bro-tek.com Bro-Tek@hotmail.com TS 354 XD _______________________________________________________________________ _________ Tools/torque/Parts required: A. Wrenches or socket (3/4”, 13/16” & 7/8”) B. Torque wrench (capacity rating range 0-96Lb-Ft =130N/M). C. Floor Jack & Jack stands. D. Pry-bar or round pipe (see pic below). E.
- Page 3 ___________________________________________________________________ www.bro-tek.com Bro-Tek@hotmail.com TS 354 XD _______________________________________________________________________ _________ careful not to damage the wheel spacers stud tread (a Wooden bar or a rag/rubber around the steel bar will help protect the treads. Get your socket & make sure to use the supplied Lug bolt that came with the spacers.
- Page 4 ___________________________________________________________________ www.bro-tek.com Bro-Tek@hotmail.com TS 354 XD _______________________________________________________________________ _________ Our recommendations would be to make witness marks after installed, using a paint pens on the back side of the axle lug bolts & also on the stud’s /lug nut of the wheel side. Make for an easy inspection of the tractor.
Need help?
Do you have a question about the Bro-Tek RS 354 XD and is the answer not in the manual?
Questions and answers