Panasonic WV-7260D Operating Instructions Manual page 5

INSTALLATION
PRECAUTION :
The following installation should be made by qualified service personnel or system installers.
e Select a flat surface capable of supporting the
combined weight of Pan/Tilt Unit, Camera Housing,
Camera and Lens.
1. The Pan/Tilt Unit must be securely fastened with four
hex head bolts (not provided) using four Mounting Holes
(4-3/8", 4-09 mm).
3-9/16"
(90mm)
8"{203mm)
2.
When mounting the outdoor camera housing on the
Mounting Plate.
Four М8х20 mm (5/16" x 13/16%һех head bolts,
plain washers and lockwashers are provided with the
Pan/Tilt Unit.
Use these to mount the camera housing as shown
below.
Be sure to align the camera direction and front direction
of pan/tilt unit.
Mounting holes for
4 WV -7135 or WV-7140
T <>
Mounting holes for
|
WV-7150D or WV-7160D $
CONNECTIONS OF THE OUTDOOR RECEIVER WV-RC150
PRECAUTION :
The following connections should be made by qualified service personnel or system installers.
A. Video and Ext. Sync Terminal Board
1. Wiring precautions:
е Do not bend coaxial cable into a curve whose radius is
smaller than 10 times diameter.
e Never staple the cable - not even with circular staples.
e Nevercrush or pinch the cable.
All these will change the impedance of the cable and
cause poor picture quality,
2. Usethe following conditions Cable
Impedance : 750
Diameter : $8 mm or less
Example : RG - 59/U (BELDEN9259)
3. Wiring
e Prepare coaxial cable as shown as below:
: Foldback
E
10mm 3mm 25mm
e Connectas follows.
1. Hold the coaxial wire,
2. Connect the inner conductor.
3. Clamp the coaxial cable (Under the embossed
side)
Ò Plain washer
| Lock washer
Hex head bolt