Panasonic WV-7260D Operating Instructions Manual page 8

ADJUSTMENTS
PRECAUTION :
The following adjustments should be made by qualified service personnel or system installers.
After the cable is assembled and unit connected, plug the 5. With both limit stops in place, pan to both stop positions
Outdoor Receiver into a 120V AC source and proceed as and recheck for exact trim of limit stops.
follows. Tighten both stops securely.
A. Panning Angle B. Tiit Limit Stop
1. Loosen the Pan Limit Stops. 1. Remove the Tilt Limit Adjustment Cover.
2. Loosen the two recessed Tilt Limit Stops and rotate
the pan/tilt head using joystick the pan/tilt contro! unit
desired up limit is reached.
3. Move the up limit stop toward bottom end of slot until a
"clock" can be heard. Tighten screw.
4. Adjust the down limit stop the same way.
5. Lock limit stops securely in place after checking for
trim.
6. Replace the cover.
Pan limit
stop (Left)
Pan limit
FRONT stop (Right)
2. Turn on the ON/ OFF switch to energize unit, then
rotate pan/tilt unit using joystick the pan/tilt control
until desired right pan limit is reached.
3. Locate the right pan limit stop and move until it contacts
limit switch actuator. Move stop additional slight
amount to deflect actuator until a "click" is heard -
indicating opening of limit switch. Lock stop in place. Up: 0° - 15° ^ | > FRONT
4. Rotate the pan/tilt head to the desired left limit position.
Adjust left pan limit stop as before.
Tilt limit Tilt limit
stop (Up) stop (Down)
TYPICAL SYSTEM CONNECTIONS
Camera Housing
WV-71 Са
Receiver System Controler WV-CU254
WV-RC150
Coax. Cable
Pre-wired
Cable
WV-CASO
Pan/Tilt Head
WV-7260D
АС 120V 60 Hz
AC 120V 60Hz