Setting The Sleep Timer - Aiwa CX-NHMT25 Operating Instructions Manual

TIMER RECORDING
Timer recording is applicable for TUNER and VIDEO/AUX (with
an external timer) sources only.
Press either TUNER BAND or VIDEO/AUX to select a source,
then press TIMER repeatedly until 5 REC appears on the
display. Within 6 seconds, carry out the steps of "SETTING
THE TIMER" from step 3 and insert the tape to be recorded on
into deck 2 after step 6.
• If the timer recording is done with the economizing mode (page
7) set to "ECO ON " or "ECO AUTO" and the power turns off,
the dimmer mode will be set to "DIMMER 3" and the volume
level will be 0 (minimum level) the next time the power is turned
on.
• You cannot use the timer function to record from a CD or tape.
• You can check the timer setting by pressing TIMER even while
the power is off. In this case, if you press ENTER or a within 4
seconds after pressing TIMER, you can enter the timer setting
mode and change the previous setting.

SETTING THE SLEEP TIMER

The unit can be turned off automatically at a specified time.
Use the remote control.
1 Press SLEEP.
2 Within 4 seconds, press f or g to specify
the time until the power is turned off.
The time changes between 5 and 240 minutes in 5-minute
steps.
MULTI JOG is also available in place of f or g.
While the timer is in operation, the display indication is dimmer
than usual.
To check the time remaining until the power is turned off
Press SLEEP once. The remaining time is displayed for 4
seconds.
To cancel the sleep timer
Press SLEEP twice so that "SLEEP oFF" appears on the display.
Specified time
21
ENGLISH
En