Related Manuals for Fisher & Paykel OB90S9LEX2
Summary of Contents for Fisher & Paykel OB90S9LEX2
- Page 1 BUILT IN OVEN OB90S9MEPX4, OB90S9MEPB1, OB90S9MEX4, OB90S9MEB1, OB90S9LEX2, OB90S9LEB1 INSTALLATION GUIDE NZ AU GB IE...
-
Page 2: Safety And Warnings
SAFETY AND WARNINGS IMPORTANT SAFETY INSTRUCTIONS WARNING ! Electrical shock hazard To avoid hazard, follow these instructions carefully Always disconnect the appliance from the before installing or using this appliance. mains power supply before Make this information available to the person carrying out any maintenance or repairs. -
Page 3: Prior To Installation
PRIOR TO INSTALLATION Before you install the oven, make sure: it will be lifted by two people. the oven will rest on a flat surface that can support its weight. the benchtop and oven cavity are square and level, and are the required dimensions. the height from the floor suits the customer. -
Page 4: Product Dimensions
PRODUCT DIMENSIONS FRONT SIDE OB90 MODELS PRODUCT DIMENSIONS (MM) Overall height of product (including upper and lower vents) Overall width of product Depth of oven front and control panel (excluding handle and dials) Depth of oven chassis (excluding oven front) Height of chassis Height of chassis at the rear Overall width of chassis... -
Page 5: Cabinetry Dimensions
CABINETRY DIMENSIONS Electrical supply 16-20 mm min. 2.5 mm IMPORTANT! Make sure the oven is installed in a SIDE cavity that is completely sealed on all sides (including top and base). This is to ensure the oven cooling system functions correctly. OB90 MODELS CABINETRY DIMENSIONS (MM) -
Page 6: Remove The Door
DISCARD PACKAGING RESPONSIBLY IMPORTANT! WARNING! When you remove the oven from the carton be careful not to damage the lower trim. The trim is important for both ventilation Very Heavy and to ensure the door opens fully without obstruction Do not attempt to lift this product unassisted. - Page 7 CONNECT THE OVEN TO THE MAINS SUPPLY IMPORTANT! This oven must be connected to the mains power supply only by a suitably qualified person. This oven must be earthed. MODEL MAX POWER (W) VOLTAGE (V) AMPS (A) OB90 4730 220 – 240 V~ 20.56 Before connecting the oven to the mains power supply, check: the domestic wiring system is suitable for the power drawn by the oven (as specified...
- Page 8 SECURE THE OVEN TO THE CABINETRY IMPORTANT! Take care not to damage the upper trim of the oven or the door sensor lever. Do not over-tighten the screws. Do not seal the oven into the cabinetry with silicone or glue. This makes future servicing difficult.
-
Page 9: Troubleshooting
TROUBLESHOOTING IF THE APPLIANCE IS NOT FUNCTIONING CORRECTLY AFTER INSTALLATION CHECK THE FOLLOWING: That the circuit breaker has not tripped or the fuse blown. Make sure that the electrical connections have been correctly made. Make sure that power is being supplied to the oven. Make sure the voltage is correct across all phases. -
Page 10: Final Checklist
FINAL CHECKLIST TO BE COMPLETED BY THE INSTALLER: Make sure the oven is level and securely fitted to the cabinetry and the oven door opens and closes freely. Make sure all the internal packaging has been removed from the oven cavity. Make sure all oven vents and openings are clear and are free of any obstruction/damage. - Page 12 FISHERPAYKEL.COM © Fisher & Paykel Appliances 2024. All rights reserved. The models shown in this guide may not be available in all markets and are subject to change at any time. The product specifications in this guide apply to the specific products and models described at the date of issue.
Need help?
Do you have a question about the OB90S9LEX2 and is the answer not in the manual?
Questions and answers