Peak SNOW BEAST SB201 Installation Instructions

WARNING: Failure to properly install wiper blades may cause the blades to not work properly or detach. Follow all instructions
carefully and use only the correct adapter for your vehicle. After installation, check to ensure the blades are securely attached.
Identify your vehicle's wiper arm and follow the instructions. Remember to remove the plastic rubber protector before installation.
1. Squeeze the sides of the front of
HOOK
the adapter and pull the adapter latch
up to open.
1. Rotate the back of the adapter up
BAYONET
and insert blade onto wiper arm.
1. Squeeze the sides of the front of
PINCH TAB
the adapter and pull the adapter latch
up to open.
To determine the size of your Push Button wiper arm, use a penny or ruler below to measure. A penny will fit firmly into the end of the 22mm wiper arm but will not fit into the end of the 19mm wiper arm.
1. Remove the pre-attached adapter
PUSH BUTTON
by grabbing the back of the adapter
(22mm)
and pulling up.
PRODUCT QUESTIONS OR COMMENTS CONTACT TECHNICAL SUPPORT:
WIPER BLADE INSTALLATION INSTRUCTIONS
2. Insert the wiper arm end through the
hole in front of the adapter and pull the
blade into the wiper arm hook. Push the
adapter latch down so it locks into place.
After installation, tug firmly on the blade
to ensure it is securely attached.
2. Ensure the dimple on the wiper arm
locks firmly into the hole on the top of
the adapter.
2. Place the wiper arm onto the adapter
so that the tabs at the back of the wiper
arm are captured by the adapter nibs.
Push the adapter latch down so it locks
in place.
2. Install the "3H-8" adapter by aligning
the arrows on the adapter with the U
hole in the blade base and snap down
into place.
(800) 477-5847 • owitech@owi.com
Scan for PEAK
and installation videos or visit PEAKauto.com
3. Fold wings on adapter forward so they
lock into place at the front of the adapter.
wiper blade product information
®
4. Insert the back end of the adapter into
the wiper arm opening. The button in the
middle of the adapter must lock into the
hole in the top of the wiper arm.