Sony HCD-MDX10 - Compact Disk Deck Receiver Component Service Manual page 24

5-5-1. Operating the Continuous Playback Mode
1. Entering the continuous playback mode
1 Set the disc in the unit. (Whichever recordable discs or discs for playback only are available.)
2 Rotate the AMS dial and display "CPLAY MODE".
3 Press the ENTER/YES button to change the display to "CPLAY MID".
4 When access completes, the display changes to "C1 =
Note : The numbers " " displayed show you error rates and ADER.
2. Changing the parts to be played back
1 Press the ENTER/YES button during continuous playback to change the display as below.
"CPLAY MID" n "CPLAY OUT" n "CPLAY IN"
When pressed another time, the parts to be played back can be moved.
2 When access completes, the display changes to "C1 =
Note : The numbers " " displayed show you error rates and ADER.
3. Ending the continuous playback mode
1 Press the MENU/NO button. The display will change to "CPLAY MODE".
2 Press the §EJECT (MD) button to remove the disc.
Note : The playback start addresses for IN, MID, and OUT are as follows.
IN 40h cluster
MID 300h cluster
OUT 700h cluster
5-5-2. Operating the Continuous Recording Mode (Use only when performing self-recording/palyback check.)
1. Entering the continuous recording mode
1 Set a recordable disc in the unit.
2 Rotate the AMS dial and display "CREC MODE".
3 Press the ENTER/YES button to change the display to "CREC MID".
4 When access completes, the display changes to "CREC (
Note : The numbers " " displayed shows you the recording position addresses.
2. Changing the parts to be recorded
1 When the ENTER/YES button is pressed during continuous recording, the display changes as below.
"CPLAY MID" n "CPLAY OUT" n "CPLAY IN"
When pressed another time, the parts to be recorded can be changed. "REC" indicator goes off.
2 When access completes, the display changes to "CREC (
Note : The numbers " " displayed shows you the recording position addresses.
3. Ending the continuous recording mode
1 Press the MENU/NO button. The display changes to "CREC MODE" and "REC" indicator goes off.
2 Press the §EJECT (MD) button to remove the disc.
Note 1 : The recording start addresses for IN, MID, and OUT are as follows.
IN 40h cluster
MID 300h cluster
OUT 700h cluster
Note 2 : The MENU/NO button can be used to stop recording anytime.
Note 3 : Do not perform continuous recording for long periods of time above 5 minutes.
Note 4 : During continuous recording, be careful not to apply vibration.
5-5-3. Non-Volatile Memory Mode (EEP MODE)
This mode reads and writes the contents of the non-volatile memory.
It is not used in servicing. If set accidentally, press the MENU/NO button immediately to exit it.
AD = ".
AD = ".
)" and "REC" indicator lights up.
)" and "REC" indicator lights up.
– 24 –