Installing The Receiver; Opening The Front Panel; Pioneer Components - Pioneer VSX-D709S Operating Instructions Manual

Operating range of remote control unit
The area in which you can use the remote control to operate the
VSX-D709S is fairly large. To use, point the remote control toward
the remote sensor on the front panel of this unit while within the
range shown right.
Remote control may not function properly if:
• There are obstacles between the remote control and the remote
sensor.
• Direct sunlight or fluorescent light is shining onto the remote
sensor.
• The receiver located near a device emitting infrared rays.
• Operated simultaneously with another remote control which
uses infrared rays.

Installing the Receiver

Please note:
• Do not place objects directly on top of this unit. This would
prevent proper heat dispersal.
• When installing in a rack, shelf, etc., be sure to leave more than
8 inches of space above the receiver.

Opening the Front Panel

To open the front panel push gently on the lower third of the panel with your
finger.
The PIONEER SR System:
Connecting an optional control cord allows you to operate other PIONEER components simply by pointing the
receiver's remote control at the remote sensor on the front panel of the receiver. The receiver then sends the
remote control signals to the other devices via the CONTROL OUT terminal.
Remote Control
memo
• You can also control PIONEER components (and those made by other manufacturers) by pointing the
receiver's remote control directly at the respective component. This type of operation does not re-
quire control cords. All you have to do is recall the appropriate the stored settings (see p.55-56).
• If you use a remote control hooked up via the CONTROL IN jack with a control cord, you won't be able
to use this unit's remote control.
Operating other PIONEER components
Receiver
SOURCE RECEIVER
component bearing
VCR VCR
DVD TV 1 2
MULTI CONTROL
CD CD-R TUN TVC
1 2 3
LOUDNESS VIDEO SELECT MULTI CH INPUT
4 5 6
the Î mark.
INPUT ATT DIGITAL NR FL DIMMER
7 8 9
REMOTE SETUP SYSTEM SETUP SIGNAL SELECT +10 DISC
0
ENTER
EFFECT/CH SEL
RECEIVER
TV
TV VOL MASTER VOLUME
TV CONTROL
TVFUNK
4 ¢
CHANNEL
TUNE
ST ST
ENTER
TUNE
GUIDE MENU
D.ACCESS BAND CLASS
& ‹ *
MPX DTV ON / OFF DTV MENU
¶ ! ⁄
RETURN S.MODE CLEAR DTV INFO
RECEIVER DIRECT CONTROL
MIDNIGHT DSP STEREO FUNCTION
ADVANCED STANDARD MUTE
2 / DSP Î
AV PRE-PROGRAMMED AND LEARNING
REMOTE CONTROL UNIT
8 inches (20 cm )
CONTROL
IN
OUT
To CONTROL IN
PIONEER
terminal of another
PIONEER component
bearing the Î mark.
Before You Start
30
30
23 feet (7m)
Receiver
11