Pioneer VSX-D709S Operating Instructions Manual page 29

ASSIGN SETUP MENU
Digital-In Select
In order to be able to use your digital equipment properly you need to assign digital inputs for each of the digital
components you connected. Match the Digital 1-4 settings with the digital jacks 1-4 in accordance with what is
connected to each digital jack. Check the digital jack numbers on the back of the receiver to make certain what
component is in which jack (if necessary, see page 13 for more on digital connections). If continuing from the
last page go to step 1. If starting fresh, complete steps 1-3 in "Setting Up for Surround Sound" (p. 27) first.
SOURCE RECEIVER
VCR VCR
DVD TV
1
MULTI CONTROL
CD CD-R TUN TVC
1 2 3
LOUDNESS VIDEO SELECT MULTI CH INPUT
4 5 6
INPUT ATT DIGITAL NR FL DIMMER
7 8 9
REMOTE SETUP SYSTEM SETUP SIGNAL SELECT
+10
0
ENTER
EFFECT/CH SEL
RECEIVER
TV
TV VOL MASTER VOLUME
TV CONTROL
TVFUNK
4 ¢
CHANNEL
TUNE
1-5
ST ST
ENTER
TUNE
GUIDE MENU
D.ACCESS BAND CLASS
& ‹ *
MPX DTV ON / OFF DTV MENU
¶ ! ⁄
RETURN S.MODE CLEAR DTV INFO
RDM
RECEIVER DIRECT CONTROL
MIDNIGHT DSP STEREO FUNCTION
ADVANCED STANDARD MUTE
2
/ DTS
AV PRE-PROGRAMMED AND LEARNING
REMOTE CONTROL UNIT
RETURN
VSX-D709S
MULTI JOG
(Turn to select / Push to enter)
The default settings are:
DIGITAL IN 1: DVD/LD
DIGITAL IN 2: CD
DIGITAL IN 3: CD-R/TAPE1/MD
DIGITAL IN 4: TV/SAT
memo
The default settings for the
DIGITAL INs are printed next to the
jacks in parentheses on the back of
the receiver.
1 "Assign Setup" should be selected (if it isn't
use the SYSTEM SETUP or SETUP buttons
2
to select it).
See "Setting Up for Surround Sound" on page 27 if you need
more information.
Press the ENTER button.
DISC
2 "Digital In" will appear in the display. To go
to the first Digital In setup press the ENTER
button.
3 "Digi-1 DVD/LD" will appear. To change the
digital input press ENTER. The input
function selected will start to flash on the
receiver's display.
Î
If you want leave it as is don't press ENTER, use the 5¥∞
buttons instead to move on to "Digi-2 CD" or another Digital In.
4 Use the 5/∞ buttons (or the MULTI JOG
dial) to choose the input function that
matches the component hooked up to that
digital terminal. Press ENTER when you've
matched the two.
The possible choices include: DVD/LD, CD, CD-R/TAPE 1/MD,
TV/SAT, VCR 1, VCR 2 You cannot assign digital inputs to the
TUNER, VIDEO, and TAPE 2 MONITOR functions.
If you assign a function (for example DVD/LD) that was previ-
ously assigned to a different Digital In the first Digital In will
automatically revert to an OFF setting. This is because one
function cannot be assigned twice.
Pressing ENTER moves you to the next DIGITAL IN. Repeat
steps 3 & 4 until all the Digital Ins are set.
5 Select "Dig-In End" with the 5¥∞ buttons
(or the MULTI JOG dial) and press ENTER to
go to Multi In Set.
If you want to change a setting before proceeding use the
arrow buttons (or the MULTI JOG dial) to go back.
Initial Set Up
\
29