CyberPower B602BRD User Manual

YOUR ULTIMATE ALLY IN POWER
6-OUTLET
SURGE PROTECTOR
B602BRD
USER MANUAL
3
1
2
Cyber Power Systems (USA), Inc.
4241 12th Avenue East, Suite 400 | Shakopee, MN 55379
FEATURES
1. ON/OFF Reset Control Switch and Circuit Breaker
Controls power to all outlets. The switch is also a 15 A
breaker. When an overload occurs, it will automatically
switch off. To resume operation, ensure the overload
condition is removed and reset the surge protector by
switching the unit ON.
2. Standard Grounded Outlets (6)
3. Braided Power Cord
CAUTION
TO REDUCE THE RISK OF ELECTRIC SHOCK:
Use only in dry locations and only indoors.
DO NOT plug into another relocatable power tap.
DO NOT "daisy chain" surge protectors.
DO NOT use with any aquarium equipment.
DO NOT use if properly grounded outlets are not available.
DO NOT install this device if there is less than 10 meters (30 feet) of wire between
the electrical outlet and electrical service panel.
DO NOT use for medical or life support equipment. This device features an internal
protection that will disconnect the surge protective component at the end of its
useful life, but it will maintain unprotected power to the load.
FOR MORE INFORMATION
Visit CyberPowerSystems.com for more information regarding:
• Product information and certifications
• Product warranty
• Connected equipment guarantee
SPECIFICATIONS
Model Number: B602BRD
Outlets: Standard Grounded Outlets (6)
Braided Power Cord Length: 2 ft
Surge Protection: 500 Joules
Electrical Rating: 125 V/15 A/60 H/1875 W
UL Clamping Voltage: UL 1449 4th/800 V (L-N)
Maximum Peak Current: 15000 A
AC Lines Protected: L-N: 15000 A
Response Time: Less than 1 nanosecond
Circuit Breaker: Resettable 15 Amp
i WARNING: This product can expose you to chemicals including bisphenol A (BPA)
and styrene (ABS), which is known to the State of California to cause reproductive
harm and cancer. For more information, go to www.P65Warnings.ca.gov.
TROUBLESHOOTING
If the ON/OFF is switched OFF, the 15 Amp circuit breaker may have tripped.
Examine your connected equipment and remove the device that is overloading
the circuit. Then, turn the ON/OFF switch back to RESET.
TECHNICAL SUPPORT
Visit: CyberPowerSystems.com/support
Toll-Free: 1-877-297-6937
© 2024 Cyber Power Systems (USA), Inc. All rights reserved. All
other trademarks are the property of their respective owners.
K01-E000031-00