SAFETY & WARNINGS Read the entire user guide before you start installation and assembly. If you have any questions regarding any of the instructions or warnings, contact your local distributor for assistance. Use with products heavier than the rated weights indicated may result in instability causing possible injury.
Page 3
COMPONENTS A (x1) B (x1) C (x1) D (x1) E (x1) F (x1) G (x1) H (x2) I (x4) J Cable Ties (x5) K M6x8 (x2) L M6x8 Screw (x2) M M6x12 Screw (x4) N M6x16 Screw (x4) O M8x20 Hex Screw (x3) P M8x75 Hex Screw (x2) Q D8 Washer (x3) R M8 Nut (x2)
Page 4
S Allen Key 3mm (x1) T Allen Key 4mm (x1) U Allen Key 6mm (x1) V Open Spanner M6x14 M8x16 10-13mm (x1) Screw (x4) Screw (x4) M6x30 M8x35 Screw (x4) D8 Washer (x4) Screw (x4) Spacer (x4) Spacer (x4)
Page 5
ASSEMBLY Step 1: Note: 2 people recommended for this step.
Page 10
Step 6: Hook the TV with brackets installed onto the floor mount. 2 people should carry the TV to prevent damage.
Page 11
Step 7: Once in place, fasten the 4 M6x12 Screws (M) to secure the brackets in place.
Page 12
Step 8: Adjusting the Vertical Tilt Loosen the 4 Allen screws slightly and adjust the vertical tilt of the TV. Note: If the display does not stop at your desired position, adjust the screws as shown.
Page 13
Step 9: Rotating the TV (Portrait/Landscape mode) • To keep the TV in landscape mode, secure it in place using the 2 M6x8 Screws (L). • To switch the TV to portrait mode, rotate the TV 90° and secure it in place using the 2 M6x8 Screws (L).
Page 14
Step 10: Secure the backing plate (G) in place using the 2 M6x16 Screws (N).
Page 15
Step 11: • Use the cable ties (J) to secure a power board or other accessories to the backing plate (G) on the rear of the TV. • Route cables through the floor mount s vertical stand.
Need help?
Do you have a question about the KATVSFWS86A and is the answer not in the manual?
Questions and answers