Toto EGO II TX468SBECBR Manual

SPECIFICATIONS
100 100
Ø54
G½
G½
G¾
OPERATING CONDITIONS
1. Water supply pressure : 0.05 ~ 0.75 MPa.
2. Ensure that water supply is clean ( No Sand, Dirt, Etc.).
ATTENTION
1.Don t use abrasive cleaners or solvents on faucets and
fittings.
2. As the product model is constantly updated, the actual
product may not look the same as it shown in the diagram,
but the basic installation principles are the same.
MAINTENANCE
All Finishes : Clean the finish with mild soap and warm water.
Wipe entire surface completely dry with clean soft cloth. Many
cleaners may contain chemicals, such as ammonia, chlorine,
toilet cleaner etc. which could adversely affect the finish and
are not recommended for cleaning
S06309BS
"EGO II" CROSS HANDLE MIXING VALVE
INSTALLATION
1.
Minimum Mortar Level
Maximum Mortar Level
To Shower *
Hot Water
Supply *
To Bath Spout *
Cold Water
Supply *
* Pipe supplied by owner
2.
Mortar
Cover *
* Remove the cover & O-ring after the mortar has dry
3.
Handle*
w/ Color
* The red handle for left position and the blue handle for
right position.
**Tighten the handle base by hand
FOR BATH & SHOWER
TROUBLESHOOTING
PROBLEM
Water leaks around the handle
Use Seal Tape
(Not Include)
O-Ring *
Handle Base**
TX468SBECBR
CHECK
SOLUTION
POINT
1 Tighten
1. CERAMIC
HEAD WORK
R4