Related Manuals for FPG ISOform I-CS-H-09-08
Summary of Contents for FPG ISOform I-CS-H-09-08
- Page 1 MODELS I-CS-H-09/12/15-08 PRODUCT MANUAL 30544 REV F AUG 2023 COUNTER 900/1200/1500 FREESTANDING/TILT FRONT/SLIDING DOOR HEATED WIDTHS: 900/1200/1500mm REAR DUAL ACTION DOORS...
- Page 2 COUNTER 900/1200/1500 FREESTANDING/TILT FRONT/SLIDING DOOR/HEATED Copyright © AUG 2023 Future Products Group Limited. All rights reserved. No part of this publication may be reproduced, stored in a retrieval system, or transmitted in any form or by any means, electronic, mechanical, photocopying, recording or otherwise, without the prior written permission of Future Products Group Ltd.
-
Page 3: Warnings
Warnings Operational This appliance is not intended for use by young children or infirm persons, Safety unless they have been adequately supervised by a responsible person, to ensure that they can use the appliance safely. Young children should be supervised, to ensure that they do not play with the appliance. -
Page 4: Table Of Contents
Caution ..............................3 Mains Supply Cord ............................ 3 Hazardous Substances ..........................3 INTRODUCTION ........................ 7 Welcome ................................7 Future Products Group (FPG) ........................7 Guidance and Help ............................ 7 Warranty ................................7 Warranty Period ............................7 Liability Exceptions ............................ 8 Specific Exclusions ............................ - Page 5 CLEANING ........................16 Cautions ................................ 16 Power ..............................16 Water ............................... 16 Caustic Products ............................. 16 Exterior ................................16 Metal Surfaces ............................16 Glass and Frames ........................... 16 Doors ............................... 16 Interior ................................17 Internal Glass ............................17 Pie chutes..............................17 Shelf Brackets ............................
- Page 6 COUNTER 900/1200/1500 FREESTANDING/TILT FRONT/SLIDING DOOR/HEATED Heating ................................22 Element Access ............................22 Element Replacement ..........................22 Test ................................. 22 Temperature Controller ........................... 22 Temperature Probe ..........................23 Fans ................................ 23 Over- Temperature Cut-out ........................23 Re-assemble ............................23 Caution ..............................23 SPECIFICATIONS ......................
-
Page 7: Introduction
These instructions cannot, however, cover all eventualities. If you are unsure of any aspect of the installation, operation or performance of your cabinet, contact your dealer or FPG. Contact details will be found on the back cover of this manual. In many cases a phone call could answer your question. -
Page 8: Liability Exceptions
• Fair wear and tear. Assessment The liability under this warranty is dependent on an assessment by FPG, to determine the defect in workmanship or materials. Time Limit FPG does not guarantee that any service to be performed under this warranty will be carried out within any particular time limit. -
Page 9: Operation
OPERATION Cabinet Layout HEATED CABINETS - OPERATION Front Access This cabinet is designed for the display of heated food items. Sliding front doors provide customer access, or a fixed tilt door may be fitted. Rear Access Dual Action swing/sliding glass doors are fitted to the rear of the cabinet. -
Page 10: Controls
COUNTER 900/1200/1500 FREESTANDING/TILT FRONT/SLIDING DOOR/HEATED Controls HEATED CABINETS - OPERATION Control Switches The main power switch and light switch are revealed by pulling the louver panel forward. The panel is held shut with magnetic catches. Simply pull the top of the panel to hinge it open. -
Page 11: Pie Chutes If Fitted
Preparation cont. HEATED CABINETS - OPERATION Pie Chutes If fitted, the pie chutes If fitted simply rest on the shelf support bars, in place of the shelf trays. The shelves are normally sloping downwards, but can be set horizontal if required. -
Page 12: Flexiplus Shelves (Optional)
COUNTER 900/1200/1500 FREESTANDING/TILT FRONT/SLIDING DOOR/HEATED FlexiPlus Shelves (Optional) HEATED CABINETS - OPERATION Shelf Access To improve access when loading products, the shelves slide outwards. Swing the rear doors open and pull evenly on the rear ticketing rail. Spring catches prevent the shelves from coming out too far. -
Page 13: Shelf Removal
FlexiPlus Shelves cont. HEATED CABINETS - OPERATION Shelf Removal The shelf trays must be lifted off before removing the shelf. Unplug the light connector, and pull the shelf out as far as it will come. Toggle the latching keys, to allow the shelf to come further out. -
Page 14: Operating Routines
COUNTER 900/1200/1500 FREESTANDING/TILT FRONT/SLIDING DOOR/HEATED Operating Routines HEATED CABINETS - OPERATION Power Supply Ensure that power is connected to the cabinet. Turn on the main power switch, as shown above. The fans will run and the cabinet temperature will begin to rise. The temperature controller is pre-set to maintain the cabinet temperature over 65, and should not need adjustment. - Page 15 TROUBLE SHOOTING FAULT POSSIBLE CAUSE REMEDY The mains isolating switch on the wall, circuit breaker or Turn isolating switch circuit fuses are off at the power breaker or fuses on board Controller faulty Have the controller replaced Check air grilles are not Cabinet does not operate/start Over-temperature cut-out obstructed...
- Page 16 COUNTER 900/1200/1500 FREESTANDING/TILT FRONT/SLIDING DOOR/HEATED CLEANING Cautions HEATED CABINETS - CLEANING Power ALWAYS TURN THE POWER SUPPLY OFF BEFORE CLEANING. Water THIS UNIT IS NOT WATERPROOF. DO NOT USE A WATER JET SPRAY TO CLEAN THE INTERIOR OR EXTERIOR OF THIS CABINET. Caustic Caustic cleaning products, such as dishwasher detergent, will cause corrosion Products...
- Page 17 Interior HEATED CABINETS - CLEANING Internal Glass The internal glass surfaces can normally be cleaned after the pie chutes have been removed. Swing open the rear doors fully, for unrestricted access. Pie chutes The pie chutes simply lift off. The tray support rails can also be removed if desired.
- Page 18 COUNTER 900/1200/1500 FREESTANDING/TILT FRONT/SLIDING DOOR/HEATED Interior HEATED CABINETS - CLEANING Access to the Lift up the fan deck to expose the Cabinet Base cable connector. Cavity Squeeze the tabs, to unplug the connector. Remove the fan deck. Lift off the cover plate to reveal the heating element.
- Page 19 INSTALLATION Regulations HEATED CABINETS INSTALLATION Compliance It is very important that your inline food cabinet is installed correctly and that the with Local operation is correct before use. Installation must comply with local electrical, Requirements health & safety and hygiene requirements. Setting Up HEATED CABINETS INSTALLATION...
- Page 20 COUNTER 900/1200/1500 FREESTANDING/TILT FRONT/SLIDING DOOR/HEATED SERVICING Caution DO NOT attempt to service the cabinet without isolating the cabinet at the supply switch or by unplugging it from the mains supply. Control Gear HEATED CABINETS - SERVICING Rear Pull the top of the louver panel, to Equipment disengage the magnet catches.
- Page 21 Lighting HEATED CABINETS - SERVICING Caution Do not service lights without isolating the cabinet from the mains supply. Test Lighting Before replacing an LED strip, check that the power supply is working. Components If there is no dc voltage at the output, the power supply should be replaced. If there is a dc output, the LED strip must be replaced.
-
Page 22: Heating
COUNTER 900/1200/1500 FREESTANDING/TILT FRONT/SLIDING DOOR/HEATED Heating HEATED CABINETS - SERVICING Element Remove all base trays to reveal the Access fan deck and element cover. Lift up the fan deck to allow the CAUTION: element cover to be lifted off. This must only be carried out by a qualified service person. -
Page 23: Temperature Probe
Heating cont. HEATED CABINETS - SERVICING Temperature The temperature control probe is Probe located in the return air stream, under the base trays. Do NOT move the probe. Fans The fan deck can be unplugged to service the fans. Press the side clips to separate the connector halves. -
Page 24: Specifications
COUNTER 900/1200/1500 FREESTANDING/TILT FRONT/SLIDING DOOR/HEATED SPECIFICATIONS Mechanical HEATED CABINETS - SPECIFICATIONS CABINET MODEL I-CS-H-09-08 I-CS-H-12-08 I-CS-H-15-08 Height 1362 mm 1362 mm Width 908 mm 1208 mm Depth 725 mm 725 mm Dry Weight Cabinet Well Material Stainless steel Cabinet Colour To Customer Specifications and silver Top Lighting Standard... -
Page 25: Controller Setting
Controller Setting HEATED CABINETS - SPECIFICATIONS LAE LTR-5CSRE Units / I-CS-H-09-08 I-CS-H-12-08 I-CS-H-15-08 Parameter Range degC Readout Scale 1ºC 1ºC 1ºC degC Minimum Limit For 1SP Setting Maximum Setting For 1SP degC Setting degC Set Point HY, PID Control Mode degC Differential Output In Case Of Probe... -
Page 26: Compliance
The cabinet complies with HACCP requirements, with the following Aspects performance: Cabinet Operating Temperature Test Conditions >65°C 22°C Ambient with 65% RH Improvements HEATED CABINETS - SPECIFICATIONS Ongoing FPG reserves the right to change specifications and construction, as part of Development ongoing product improvement. © FUTURE PRODUCTS GROUP... -
Page 27: Electrical Circuit Diagrams
ELECTRICAL CIRCUIT DIAGRAMS Model: I-CS-H-09-08 Isoform Counter 900 Heated Model: I-CS-H-12-08 Isoform Counter 1200 Heated MODELS I-CS-H-09/12/15-08... -
Page 28: Model: I-Cs-H-15-08
COUNTER 900/1200/1500 FREESTANDING/TILT FRONT/SLIDING DOOR/HEATED Model: I-CS-H-15-08 Isoform Counter 1500 Heated © FUTURE PRODUCTS GROUP... -
Page 29: Spare Parts
When ordering spare parts, it is important to quote the Serial Number printed on Number the label fixed to the control panel. This will enable FPG to trace details of the build specification of your particular cabinet, and hence ensure that spare parts are fully compatible. - Page 30 FREESTANDING/TILT FRONT/SLIDING DOOR/HEATED Spare Parts continued Handed parts, in the following table, are as viewed from the back of the cabinet. Part Description FPG Part No. Left front slide door 900 76567 Right front slide door 900 76566 Left front slide door 1200...
-
Page 31: Door Seal Identification
Spare Parts continued Door Seal Front Sliding Door Seals Identification Rear Dual Action Door Seals MODELS I-CS-H-09/12/15-08... -
Page 32: Mechanical Drawings
COUNTER 900/1200/1500 FREESTANDING/TILT FRONT/SLIDING DOOR/HEATED MECHANICAL DRAWINGS Model: I-CS-H-09/12/15-08 Mountings The standard cabinet has 150mm legs. Alternatively, cabinets can be fitted with casters, or 100mm legs. © FUTURE PRODUCTS GROUP... - Page 33 MODELS I-CS-H-09/12/15-08...
- Page 34 COUNTER 900/1200/1500 FREESTANDING/TILT FRONT/SLIDING DOOR/HEATED © FUTURE PRODUCTS GROUP...
-
Page 35: Revision History
Revision History Revision Date of Change Details Level Change 07/07/23 Controller settings updated. Door seal information added, part numbers revised 02/08/23 Controller differential setting altered from 1 to -1 MODELS I-CS-H-09/12/15-08... - Page 36 PRODUCT MANUAL 30544 REV F AUG 2023 In line with our policy to continually develop, improve and support our products, Future Products Group Ltd reserves the right to change specifications and design without notice. Have a question? Please email us at: sales@fpgworld.com or visit www.fpgworld.com...
Need help?
Do you have a question about the ISOform I-CS-H-09-08 and is the answer not in the manual?
Questions and answers