Advertisement

Quick Links

This Owner's Manual is provided and hosted by Appliance Factory Parts.
GrillPro 236464
Owner's Manual
Shop genuine replacement parts for GrillPro 236464
Find Your GrillPro Grill Parts - Select From 131 Models
-------- Manual continues below --------

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the GrillPro 236464 and is the answer not in the manual?

Questions and answers

Summary of Contents for Onward GrillPro 236464

  • Page 1 This Owner's Manual is provided and hosted by Appliance Factory Parts. GrillPro 236464 Owner's Manual Shop genuine replacement parts for GrillPro 236464 Find Your GrillPro Grill Parts - Select From 131 Models -------- Manual continues below --------...
  • Page 2: Table Of Contents

    OWNER'S MANUAL FOR USE WITH L.P. GAS (LIQUIFIED PETROLEUM GAS) IN CANADA - PROPANE GAS ANSI Z21.58/C.G.A. 1.6 - LATEST EDITION CONTENTS SAFETY……………………………………….2 INSTALLATION………………………………2 L.P. GAS CYLINDER………………………..3 OPD EQUIPPED CYLINDER………….…...4 HOSE & REGULATOR……………….……..4 LEAK TESTING……………………….……..5 VENTURI TUBES………………….………...5 Please record your model and LIGHTING………………………….…………6 serial number here.
  • Page 3: Safety

    SAFETY INSTALLATION Your new OMC gas grill is a safe, convenient appliance 1. This appliance must be installed in accordancewith when assembled and used properly. However, as with the local code, or in the absence of local codes, with all gas-fired products, certain safeguards must be either the National Fuel Gas Code, ANSI Z223.1/NFPA observed.
  • Page 4: Gas Cylinder

    LP GAS CYLINDER ® The cylinder supply system must be arranged for -1 QUICK CLOSING COUPLING vapour withdrawal. All models are designed to be used with an LP gas cylinder ® The cylinder must include a collar to protect the cylinder equipped with the new QCC -1 Quick Closing Coupling valve.
  • Page 5: Opd Equipped Cylinder

    OPD EQUIPPED CYLINDER HOSE & REGULATOR All models are equipped with a hose and regulator with a OVERFILL PREVENTION DEVICE ® -1 Quick Closing Coupling. Effective January 1, 1998, the standard for outdoor gas ® 1. The QCC coupling contains a magnetic Flow Limiting appliances, ANSI Z21.58/CAN/CGA-1.6, requires that Device which will limit the flow of gas should there be a appliances are to be used with cylinders equipped with an...
  • Page 6: Leak Testing

    LEAK TESTING VENTURI TUBES • All factory-made connections have been thoroughly tested KEEP VENTURI TUBES CLEAN. for gas leaks. However, shipping and handling may have • Blockages caused by spiders insects and nests loosened a gas fitting. can cause a flashback fire. AS A SAFETY PRECAUTION: Although the barbecue might still light, the backed up gas •...
  • Page 7: Lighting

    LIGHTING 9b. For Side Burner: Push and turn side burner control knob to "Hi." Push or rotate the ignitor knob 3 or 4 times. Burner should ignite within 5 seconds. Note: To light burner with a match follow steps 1 thru 8 above.
  • Page 8: Operation

    OPERATION COOKING TECHNIQUES Burn-off. Before cooking on your gas barbecue for the PREPARATION: first time, burn off the barbecue to rid it of any odors or 1. Prepare food in advance to avoid delay and timing foreign matter as follows: problems.
  • Page 9 COOKING TECHNIQUES 3. Fasten the meat securely on the spit prior to placing GRILL COOKING it on the barbecue. For poultry, tie the wings and 6. Grilling with the cover closed on low heat will legs in tightly to avoid contact with drip pan. enhance the "smoked"...
  • Page 10 COOKING TECHNIQUES HOW TO USE A SPIT SPIT BALANCE LEG OF LAMB 1. Have 3" of bone sawed from small end of leg. Leave meat around bone intact to form a flap. Put a spit fork on rod. 1. Loosen the rod handle to allow the balance to turn Fold flap up and run rod through flap and leg.
  • Page 11: Maintenance

    MAINTENANCE General Cleaning PERIODIC MAINTENANCE After you have finished, prepare for the next cookout by When the barbecue is cold, remove the grids. If equipped burning off any residue of food from the grid and with briquets, turn over. Cover three quarters of the briquets/Flav-R-Wave/Flav-R-Cast in the following manner: briquets/Flav-R-Wave/Flav-R-Cast with aluminum foil, shiny side down.
  • Page 12: Trouble Shooting

    TROUBLE SHOOTING PROBLEM POSSIBLE CAUSE CORRECTIVE ACTION SMELL OF GAS SHUT OFF LP GAS CYLINDER VALVE AT ONCE. DO NOT USE THE APPLIANCE UNTIL LEAK IS SEALED. Leak detected at cylinder, regulator or Regulator fitting loose. Tighten fitting and "Leak Test". other connection.
  • Page 13: Warranty

    WARRANTY BURNERS The OMC Warranty is effective from date of purchase and is limited to the repair or replacement of parts at no charge which The life of OMC burners (made of stainless steel) depends prove to be defective under normal domestic use. almost entirely on proper use, cleaning and maintenance.

Table of Contents