Advertisement
Quick Links
WARRANTY INFORMATION:
All SSV Works enclosures are covered by a limited lifetime warranty against defects in material or
workmanship. All SSV Works Electronics are covered by a limited 1 year warranty against defects in
material or workmanship. All SSV Works Speakers are covered by a limited 1 year warranty against
defects in material or workmanship. Labor for replacement of defective components is not covered.
Contact SSV Works for further warranty information.
Polaris RZR XP Pro & XP4 Pro
Under Rear Seat Subwoofer Enclosure 10"
!
RZ5-BS10
Please read and understand these
instructions completely before
installation to avoid possible injury, or
damage to the accessory or vehicle.
Advertisement
Related Manuals for SSV Works RZ5-BS10
Summary of Contents for SSV Works RZ5-BS10
- Page 1 WARRANTY INFORMATION: Please read and understand these All SSV Works enclosures are covered by a limited lifetime warranty against defects in material or instructions completely before workmanship. All SSV Works Electronics are covered by a limited 1 year warranty against defects in installation to avoid possible injury, or material or workmanship.
- Page 2 UNDER REAR SEAT SUBWOOFER ENCLOSURE PARTS LIST PARTS LIST IMAGES RZ5-BS10 Enclosure Bracket Pack (B-MBP3009) 2-PIN Subwoofer Extension M6x16, Flanged Reduced Harness (8FT) [B-H2702] Head Screws and Washers, 4 pack (x2) [B-HPM616HH-4] UNDER REAR SEAT SUBWOOFER ENCLOSURE ASSEMBLY TOOLS NEEDED FOR INSTALLATION...
- Page 3 UNDER REAR SEAT SUBWOOFER ENCLOSURE INSTALLATION TOOLS NEEDED FOR INSTALLATION - T40 Torx Driver - 13mm &15mm Socket Wrench A. Depress the lever behind the headrest to release the backrest. B. Detach seat belts to gain access to the bottom seat tray. C.
- Page 4 UNDER REAR SEAT SUBWOOFER ENCLOSURE INSTALLATION F. Remove the H bracket using a 15mm socket and box wrench. G. There is a heat shield bolted to the H bracket. Some models use (2) T40 Torx screws [G] and some use (2) 10mm hex head screws [G1] to secure the heat shield.
- Page 5 UNDER REAR SEAT SUBWOOFER ENCLOSURE INSTALLATION J. Secure the enclosure brackets using the M6x16mm screws. Only hand K. Once all bracket screws are installed, tighten the screws using a 15mm tighten each one until all the screws are aligned to the inserts. and 8mm socket and/or box wrench.
- Page 6 © 2024 SSV Works, Oxnard, CA 93030 RZ5-BS10 Rev. A 1-23-24...
Need help?
Do you have a question about the RZ5-BS10 and is the answer not in the manual?
Questions and answers